Take off the left wheel. Take the splash panel off the inner fender. Take the nut off the end of the half shaft. With a hammer and a punch dislodge the driveshaft from the hub. Take the center cross arm off. Then pry the axle out of the transmission with a good pry bar. Use a lot of force. They are real boogers to get out.
replace front brake discs and pads.
The front bearing for a Dodge Stratus is attached to the Hub. To replace it remove all the components on the hub assembly. There are three bolts that hold the assembly in place. Loosen the bolts and pry out the hub. Replace the unit.
Insert the window into frame
To replace the headlight assembly on a 2006 Jetta, remove the front grill. Then remove the headlight assembly by taking off the screws that secure it in place. Replace with new.Ê
It's looks like this ->O
Open the hood. Near the front of the turn signal assembly there is a Phillips head screw. Loosen but do not remove the screw; it releases the front of the assembly. You then need to pull forward to release the pin holding the rear of the assembly. Reverse the above to replace the assembly.
Most ford escort horns were located somewhere behind the front bumper, usually on the right-hand side.
No, the entire assembly needs to be replaced.
Remove the fasteners and electrical connection from behind the assembly and slide the assembly out the front.
Front or rear?
It looks as if I'll have to crawl under the front of the car to access the bulb to replace it.
If you have a state safety inspection, bring to inspection station for alignment