That's one of the pickiest things to do. On some washers you can raise the whole top surface to do it, on others you have to take the whole casing off. Look carefully along the front seam, where lid sits on casing, you may see two clips. If you do slip a flat screwdriver just into the slit and try to wedge it open. If it doesn't work then you have the other kind, sorry.
If your washing machine will agitate, but refuses to spin out, you more than likely have a bad lid switch. A lid switch, when working properly, tells the washing machine when the lid is closed, thus allowing the washer to spin out. A faulty switch will signal that the lid is still open, even though it isn't, and the water will not spin out. Repairing a lid switch is easy for the average do-it-yourself person with some instructions from internet sources, especially videos. These switches will run anywhere from $20-$60 depending on the machine and are found at your local appliance repair centers.
The pump may be bad or weak. You can check the small lid switch under the lid. When you close the lid...it will engage. These will sometimes get out of sinc with the lid and not engage.
If a Maytag washer fills with water but does not agitate it could a problem with the switch in the lid. There is a switch that locks the lid down during agitation and spinning. The magnet could be defective.
1920's washing machines didn't have a lid. You would have to get the hose from the garden and fill the washer machine up!
There is a safety switch on all washers and dryers to stop accidents. It turns off power when the lid is raised. Most likely the switch needs adjustment if the machine goes into normal cycle when you lift the lid. Locate switch and adjust to make it less sensitive. First turn power off, remove plug.
There should be a tag under the lid on the rim of the opening.
If you are sure the lid safety switch is at fault do not bother with it, they are cheaper and easier to replace
The wig-wag or spin actuator or belt is faulty. -Simple problem for someone experienced in washing machines.
It sounds like a lid switch to me. i just don't know what a Kirkland signature machine is like, but all machines have some kind of switch to make it turn on And when they go out your machine will not drain. Go to Youtube and see if they have that type and they will show you how to fix it step by step. It's free
either the lid switch is bad or the transmission is faulty. The Whirlpool and their subsidiaries brand(s) are well known for faulty or broken lid switches which break from the users either dropping or slamming their lids. The weight combined with force,breaks the switch and will keep them from agitating,draining or spinning.
Okay people, here is how you load a washing machine, *Turn the washing machine on, *Put the recommended amount of detergent in, *put your clothes in - unfold and turn clothing inside out - do not overfill the machine *close the lid. DONE!!! Another This is my procedure for a top loading machine: Turn on, add appropriate amount of soap powder/detergent, start water until powder dissolves, add laundry then continue water to fill, close lid & start wash/rinse cycle.
Washing machine filters are cleaned not changed unless they are broken, they are usually inside above the wash bin, check the instructions inside the lid or your owners manual for the location of yours.