This is a big job requiring the use of a press to remove and install the bearing. I have done this in my own garage, taking the hub out to a local garage for the press work. However, since you are asking here, you should have the whole job done by a mechanic that you trust. It is a big job. --Ken
Ask the mechanic who is willing to do the job. No other answer has any meaning.
There is an axle for each wheel.
The answer is always the same. The only estimate that has any value whatsoever is from the person willing to perform the job. Start with your Subaru dealer. --Ken
Go to the auto parts store and get a manual for your Forester, like the Haynes. It has a full description of how to do the job. After reviewing the procedure, if you think that your skill level is up to the task, have at it. Otherwise, take it to a professional. --Ken
You can replace the front wheel bearing, on your Kawasaki Mule 3010, by removing the axle. With the axle Remove the wheel bearing will slide off.
you will have to have the axle pulled at a shop.the bearing slides along the axle shaft and seats in the axle housing.
Remove the tire and wheel. Remove the axle end. Remove the axle seal. Remove the wheel bearing. Reverse the process to install the new wheel bearing.
how hard is it to replace a rear wheel bearing 1999 Honda crv. this crv does not have rear axle's in it. thank you
Remove the rear wheel from the axle. Remove the brake pads and hardware. Remove the axle end cap. Remove the bearing. Reverse the process to install the new bearing.
If you do not change a bad wheel bearing the bearing will cut a groov in the axle.If it goes on long enough the axle will have to be replaced.It could also ruin the axle housing.Then you would have to replace the rearend.
No.If the axle has groves in it,you need to replace it.There is a bearing that is called a REPAIR BEARING that can be used.But it depends on how badly the axle is damaged.
How do you replace a rear wheel assembly?