Put down top preferably
2 buttons under the seat, push them in and pull up on bottom part of seat one side at a time, i had to beat mine in.
Pull out bottom seat and set aside.
2 screws for top part of back seat, remove them down low then pull up and wiggle to remove top seat, set aside.
Pull up sill plate on door and set aside.
Pull all the pressure fit "grommets" from trim including one where top goes down, 2 where upper seat was, one where lower seat was, and 2 little ones where door shuts. pull up and set aside, I left seat belt in.
Remove screws for speaker case and pull speaker case and set aside. I think 3 screws.
Pry out the plate that is adhesived to side of car, black plate protects motor.
Now disconnect wiring harness for motor and unscrew motor. Put new one in screw it tight and test it out.
Put everything back the way it was. Have fun.
go to your local machanic
Behind the back seat
You will have to drill out the rivets. When reinstalling you can use bolts and nuts if you don't have rivets.
video on how to replace window lift motor on j30
According to the 2003 Ford Mustang Owner Guide : ( Motorcraft MERCON automatic transmission fluid is used for the convertible top )
How to remove the window motor from the regulator
replace a window lift motor for a 2002 gmc sierra?
replace 1987 dodge pickup/power window motor
Yes
when replacing motor what position does the window need to be in?
don't just replace the window motor replace the whole car. get a hybrid or something
Only if you change out the entire regulator. The power regulator unit is pitched a little different due to the power motor components.