Want this question answered?
how do i take the rocker cover off to change the gasketon a 2001 2.7 hilux petrol
Rocker cover gaskets need to be replaced.
The oil leak is coming from the valve cover gasket and leaking onto the exhaust manifold, the rubber valve cover gaskets get hard from the engine heat and start to leak, you will have to replace the rubber valve cover gaskets to stop the oil leak
Because your'e spark plug pipe gaskets and your'e valve (rocker) cover gaskets are shot! The swell your'e rubber boots cause misfires. Replace them all. Good for 40 or 50k. T Ray.
On 4 cylinder it takes about 20-30 minutes. For V-6 it might take couple hours.
The cost to replace valve cover gaskets on a 2001 Subaru Legacy is about $600. If the work is done at home the cost is only $100 to $200.
I'm going to replace the valve cover gaskets on my 5.4. The top bolts their very loose, but hesitant to come out. any thing would help me
They are under the rocker cover. You'll need to replace the rocker cover seal aswel if your replacing the glow plugs.
I am assuming you mean "rocker cover" gasket. All you have to do is simply take the cover off, peal away all the old gasket, clean both gasket surfaces, and then use a small amount of RTV silicone in the corners of rubber gaskets (NOT CORK GASKETS) and then re-install the new gasket in place of the old one.
Yes, there is a problem with the design of the 2002-2003 valve covers. It's best to replace them with valve cover (rocker cover) for a 2004 maxima. They are exact fit, work better and are MUCH cheaper than the 02-03 valve covers. You must order gaskets seperately and the 04 valve covers come with a new PCV as well.
Subject: Sportster 1200 rear rocker coverQuestionI've replaced my front rocker cover gaskets due to an oil leak. Now I can't get the rear rocker cover off. I've removed the top bolts but the frame is blocking the removal of the cover. Is there an easy way to remove the covers?AnswerSorry I didnt answer you sooner. My hard drive decided to go south!The rocker cover will come off without removing the motor. Its a tight fit and you have to turn it to get it out, but it will come out. If you are removing the lower rocker cover you have to remove the pushrods to get it out.Good luck and happy ridingMike
cadillac catera replace valve cover gasket 1997