Light bulb changed. I removed a Philips head screw under a plastic cover on the lower edge of the light housing. Slid the light assembly off the hook at the top and accessed the socket replaced the bulb. Slid the light assembly back on the hook, replaced the scew and snapped on the plastic cap covering the screw. Never did find two screws under the carpet in the trunk. Thanks, but we figured it out.
I never found the Phillips screw. SOOO Open the Trunk at the back there are 2 little doors held closed with velcro. Open these doors. When you have figured out what is burned out, remember "Righty Tighty, Lefty Loosey". Rotate the socket mechanism left and gently pull the light and sockett out and remove the bulb. I suggest that if you have one out you should replace both right and left sides bulbs. Good Luck!
how to replace tail lamp 2005 xterra
Remove tail light housing. Remove lamp. Replace lamp. Replace tail light housing.
5657439929222222220
Follow the link below, labeled "How to replace a Lexus IS300 tail light"
Open trunk. With a deep nut driver remove the three nuts that hold the tail lamp in place. Gently pull the tail lamp from its mount. Remove the lamp socket but turning is slightly to the left. Pull old bulb out gently. Us a rag or glove in case the bulb breaks. Insert new bulb into the socket replace the socket into the tail lamp housing and install the tail lamp. Be careful that the screws are aligned through the holes and the tail lamp is properly seated before tightening the nuts.
There is no reset for taillamp failure relay. If there is a fault the message will continue to be displayed www.lextechautomotivellc.com
2008 Lexus RX350 tail light bulb lamp replacement: Purchase the correct replacement tail light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the tail light bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
It is a Pontiac Aztek. Light a match and get some marshmallows.
Open trunk, pull back trunk lining on side to be replaced. Remove three plastic wing nuts, pull tail lamp away from car body, disconnect wiring harness from tail lamp, replace defective bulb.
open the lift-gate and take off the tail lamp
tke a screwdriver and remove the screws and take out the tail lamp. otherewise take a hammer and break the tail lamp
For any Gen II (1995 - 2005) Blazer, Jimmy, or Bravada, it's all the same. Open the hatch. On the side of the door jamb, you'll see two screws - those hold the tail lamp assembly in place. Remove those, and the whole tail lamp assembly will come out. The bulb holders are in the back of the tail lamp assembly - rotate them counterclockwise, and they will come out. Then you can replace the bulb, put the lamp holder back into the tail lamp assembly, and the installation is the opposite of removal. Pretty simple stuff.. only tools required are a short Phillips screwdriver.