answersLogoWhite

0


Best Answer
Copy

remove the two screws from the lens, open the tailgate and remove two more screws, twist the plug from the back side of the lens to expose the light, twist and pull out the bulb

User Avatar

Wiki User

โˆ™ 2015-07-15 21:14:20
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you replace tail lights and blinkers in a 1997 Chevy S-10?
Write your answer...
Submit

Related Questions

How do you replace tail lights and blinkers in a 1997 Chevy?

Drop the tailgate, access the screws to remove the taillight assembly. Remove the screws holding the circuit board to the assembly, pull the board and you will have access to the bulbs.


Why would blinkers and hazard lights on a 1997 Dodge Intrepid stop working?

u need to replace with a turnsignal light switch . there is a short in steering column


Replace heater core in 1997 Chevy blazer?

how to replace a heater core in a 1997 Chevy blazer


My 1997 Honda Shadow Ace 1100 lights are dim and no tail lights no blinkers and no power to starter?

Dead battery or dirty/corroded terminals


Your brake lights and head lights do not work your blinkers and running lights do?

My rear window brake light works, but not my tail light brakes on my 1997 Monte Carlo. What is the problem?


What causes the blinkers not to work on a 1997 Mitzubishi Eclipse Spyder?

Check/replace turn signal flasher


Why do your blinkers stay on and don't blink on your 1997 blazer?

Possibly a defective Flasher Relay. Replace the relay.


Why would brake lights on 1997 Chevy Camero not work when lights are on?

The bulbs are burnt out.


Do 1997 Chevy silverado have daytime running lights?

Yes


How do you wire trailer lights on 1997 Chevy blazer?

with wires


How do you replace the evaporator on a 1997 Chevy silverado c1500 ext cab?

how to clean evaporator on 1997 chevy 1500


How do i replace the purge valve on a 1997 Chevy Monte Carlo?

How do i replace the purge valve on a 1999 Chevy Monte Carlo


Why doesn't the blinkers on your 1997 Chevy S-10 blazer work if all the bulb and hazards work?

The blinker is on a separate fuse from the hazard lights. You probably need a fuse just for your directionals. It is located right next to the fuse for the hazards.


What is the cost to replace a thermostat in 1997 Chevy lumina?

100


Where are the hazard lights on a 1997 Chevy Monte Carlo located?

the location of the hazard lights is on top of the steering colum.


Why do lights flicker 1997 Chevy Lumina?

the regulator is getting bad in the alternator


Why wouldn't the daytime running lights work on a 1997 Chevy?

Look in the fuse box for a fuse marked DT lights


How do you replace the dashboard lights on 1997 F-150?

To replace the dashboard lights on the 1997 F-150, you will first need to remove the dash bezel and dash cover in order to access the lights. Then, remove the instrument panel cover below the bezel and remove the burned out lights. Replace the lights and add the cover, dash cover, and bezel back to the dashboard.


How do you replace timing belt on a 1997 Chevy Suburban?

The 97 Chevy Suburban doesn't have a timing belt.


Cost to replace washer fluid reservoir on 1997 Chevy Malibu?

what is the labor cost to replace a wiper reservior bottle in a 2002 Chevy Malibu


How do you replace a radiator on a 1997 Chevy Cavalier?

I've got a better question, why is this question in the Chevy venture forum ?


How does the door turn off interior lights on a Chevy S10 1997?

Closing the door turns off interior lights on a 1997 Chevy S10 because there is a switch in the door jamb that closes when the door shuts. When the door opens, the switch opens.


How do you replace the water pump on a 1997 Chevy Tahoe?

yopu have to have a special tool to do it .


How do you replace corner lights on 1997 Toyota Corolla?

how do you replace 1999 Toyota corolla corner light - passenger side


1997 Lumina. Hazard lights cruise control blinkers tail lights work. Brake lights do not. Replaced activating switch and turn signal switch bulbs fuse checked for corrosion and broken wires. Pls help?

To replace turn signal control module requires removing steering wheel. Took mine to a dealer - $245 out the door. Brake lights work great now.