How to replace the EGR valve on 1998-2002 Honda Accord 2.3 I4 (F23a) # Make sure engine is completely cool! Remember, you are working on a portion of the engine that deals with the exhaust. # Disconnect the battery. Its not necessary but advised. # Looking at the engine from the front of the car, the EGR valve is directly behind the left back side of the valve cover. It is black and round on the top, about 1.5 inches in diameter. It will have an electrical connection plug coming out of the side of it. # Remove the electrical plug. # Looking straight down at the EGR valve, you will see the two 12mm bolts holding it to the manifold. # Remove the two 12mm bolts using a deep socket and extension on a 3/8" ratchet. Careful not to drop or loose the bolts! # The EGR valve should pull straight up and off at that point. # Since you have the EGR off, it would be a good idea to clean the ports using some type of aerosol cleaner( brake clean works) and a rag. # Make sure ALL of the old gasket is off the manifold and there is a nice clean surface to bolt the new EGR valve on to. # Line up the new gasket and install new valve by reversing the removal instructions. # If your check engine light was on, it should reset itself and stay off if you disconnected the positive battery terminal during your install. If you left the positive terminal hooked up, disconnect for several minutes to reset the ECU.
There was not a 1999 Honda Accord LXi made. Do you have a 1989 Honda Accord LXi?
dash light location on a 1999 hound accord V6
visit the parts store and look in the chilton manual for your make and model it should have the answers you seek
Click the link.
Click the link.
The transmission filter on a 1999 Honda Accord can be located under the car's hood. More specifically, it is within the transmission itself and is very difficult to replace.
So, ... what is your question?
Only when it fails.
Plugs, wires, rotor, cap, pcv valve.
Have someone else do it for you.
Replace your distributor cap, it probably has a crack in it.
Front studs on a 1999 Honda Accord are pressed in. First the studs must be removed using a hammer or press. Once remove each stud can be pressed in.