To replace the fog light of the passenger side you need to remove the fog light bolt and pull out the fog light assembly, then you can remove the bulb and put a new one in.
To replace the fog light on the driver side you will need to remove the front bumper cover so you can remove the vacuum box that is in the the way of the fog light bolt.
To do so you need to remove the Torx (star) screws located in the front wheel wells as well as the bolts holding the plastic by the radiator. "CAUTION: DO NOT UNBOLT THE RADIATOR."
If any of the screws are rusted into place put some penetrating oil them to help loosen them up.
To replace the parking light bulbs, remove the screw on top of the headlight and pop out the clearance light. The parking light bulb will be accessible after this removal.
my left turn signal on my 1997 dodge conversion van works fine,the right signal lights but does not blink,,,,any ideas
Buy Sylvania Bulbs, 7443 type 12 volt
The brake lights are located in the trunk of a 1997 Acura Integra. To replace them open the trunk and find the plastic housing. Remove and replace the bulbs.
Your switch on your sterring wheel colum is bad. Replace.
How much should it cost to replace the airbags on a 1997 dodge stratus?
If the turn signal bulbs light but will not flash, the flasher relay is defective, replace it.
To replace the bulbs in a 1997 Acura safely prop the hood open. Locate the front headlights and remove the old lights. Replace the bulbs.
Yes you can just replace the headlight bulbs. First you have to take out the cover by the battery. Then unscrew the cover by the radiator and simply lift it up to take it off. The light bulbs are visible at this time.
the rear bulbs are replaced by removing two screws and pulling the assy out then the bulbs twist out, the front twist out of the composite light assy
Some are accessable from the trunk. If not, take the light assy off.
tail lights circuit