answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you replace the ac compressor pulley bearing on a Volvo s80?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace a wheel bearing on a 2007 Volvo s40?

To replace a wheel bearing on a 2007 Volvo S40 you need to remove the caliper bolts first and then extract the car's rotor. Then you must put the new bearing on the knuckle.


How do you replace a wheel bearing on a Volvo v50?

In order to replace a wheel bearing, the tire must first be removed on a Volvo v50. The wheel cowling can be removed exposing the bearings. After taking the bearings out, clean the housing and repack the bearings.


How do you wheel bearing for Volvo s80?

Wheel bearing are what allow wheels to spin smoothing on an axle. A broken wheel bearing can lead to fatal car accidents. To replace a wheel bearing on a Volvo s80 remove the wheel hub and have the bearing pressed out. Press the new bearing into the wheel hub to ensure a safe install.


AC relay Volvo 940 compressor?

Location ac compressor relay 940 volvo


Is it possible to eliminate the AC compressor to drive power steering pump on a 1986 Volvo 240 DL?

IPD makes a kit for some Volvos, depends on if the pulleys line up correctly. If not, get an empty, but spinning, compressor from junkjard to act as pulley.


How do you remove a 1983 Volvo wagons AC belt in order to replace timing belt?

On the 1983 model: The large York compressor is stationary and non-adjustable. In order to remove the belt, you have to remove the bolts that surround the large bolt on the crankshaft pulley. Once those small bolts (10mm socket) are removed, the 'split' pulley separates and the belt literally falls off.


Why does your 1998 Volvo S80 keep blowing a fuse when the AC compressor kicks on?

Compressor has seized.


Where are the timing marks on the 2001 Volvo S40?

The timing marks on your 2001 Volvo S40 can be found on the outside of the main pulley. The timing marks will be scattered around the edge of the pulley.


How do you replace Volvo S80 fuel filter?

How do you replace a fuel filter on a 1999 s80 Volvo?


Where is the low pressure port on a 1997 Volvo 850?

The 1997 Volvo 850 low pressure port is located on the air conditioning compressor. The low pressure port will be on the right hand side of the compressor.


How do you set the timing on a 87 Volvo 240 with a b230 engine?

Loosen the Tensioner pulley and push against the spring, and put a nail in the small hole to lock the spring back. Align the Crank pulley, Intermediate shaft, and Cam pulley to TDC, look for the notches for reference. Then put the belt on the gears in that order, and re check. Then pull the nail, and lock the bearing in place to keep correct tension.


When do you change timing belt on Volvo S60?

Volvo recommended interval is 105,000 miles. You also replace the tensioner and the idler pulley at this time. 96000 miles You might also consider replacing the water pump at this time, it's driven by the timing belt and requires very little more labor to replace while you have the timing belt off.