0
How do you replace the antenna rubber cap assembly on the 2001 Mercedes E320?
Wiki User
∙ 16y ago
yOU CAN GO TO EBAY AND LOOK UP MERCEDES ANTENNA. 'GUY SELLS ONE THAT WLL FIT.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you replace a wiper blade on a 2002 Nissan Frontier?
I had to replace the whole blade assembly. The rubber blade did not come off. The replacement blade from autozone came with the whole assembly. Cost wasn't much more than just the rubber blade style.
How do you replace a 1994 Honda Prelude antenna?
You would need to get a tool to remove the notched chrome piece that holds the antenna mast, or carefully use pliers to unscrew it out. After you remove that, the antenna itself is held by a 10mm bolt. to get to it you'll need to open up the trunk lining near the antenna location and remove that bolt. Then, pull the antenna far enough to disconnect the antenna wire and power. Assuming the antenna motor is still functional, you can then replace the antenna mast with a new one. Or, you can install an aftermarket rubber antenna.
How do you adjust Mercedes C180 wiper parking position?
use the bolt on the base base of the wiper assembly wich secures the rubber mounting
Where to findbuy a new antenna capthe black rubber portion for a 2000 E320?
Unfortunately from a Dealer. It comes as the whole cover assembly and sells for roughly $109. Sorry
How do you change bulb in high brake light in 2005 Chrysler town and country?
Open lift gate Notice what appears to be a small, round rubber "bumper" on the inside of the vehicle opposite the tail light lens. Carefully pry the rubber "bumper" out. This will loosen the tail light lens so you can now pull the lens assembly away. Replace the defective bulb. Replace lens assembly. Re-install the rubber "bumper".
How do you replace electric antenne in 1994 Mercedes 500sl?
First remove the lock cap on the base of the antenna. It may require a pair of pliers. It is chrome. Once that is removed. Remove the black rubber trim cap. Work it left and right, it will slide off. Once that is done, open the trunk and remove the push pins in the driver side trim panel against the quarter panel. Remove the brake light assembly, this has a spring clip and hinges. Once the push pins are removed, bend the carpet panel back out of the way. There are 2 screws holding the assembly. One is a large Philips that mounts the assembly, the other is a small Philips, it is for the ground. Pull the assembly downward. As you pull down be gentle, there us a metal guide assmbly that has a spring that holds it tight to the xterior lock nut. It took me about 15 minutes to change the antenna. Farily simple to repair if the mast is drive is broken,
What wiper blades fit the 2006 Honda civic?
You need to get the wiper blade from the dealership. You can just replace the wiper rubber. It slides into the wiper assembly at a cost of about $5, or replace the whole unit for around $50 each. I replaced the rubber part on mine and it's great.
How do you replace brake lights on 2002 Hyundai Santa Fe?
Lift the back door & you will see 2 screws securing the tail light assembly, take them out & gently wiggle the assembly to release the 2 rubber locating pins, & that will give you access to all the globes in the tail light assembly.
How do you remove the antenna mast nut on a 1997 cadillac deville power antenna?
this is replaced as a complete unit installed in the passenger side of the trunk, just pull the side trim out of the way. one 10mm socket and one 10mm wrench. remove the ground srtap bolt from the chassis and unplug the two connectors and pull assembly down out of the rubber.
How do you replace the headlight assembly located on a 1999 VW Passat?
I have a 2001 pre-model changeover which should be similar to 1999. I'm not sure if you mean replacing the headlight bulb but if that's the case you would pull out the round rubber grommet and that makes the bulb assembly accessible. You just unclip it, pull it out and replace the bulb...To change the headlight assembly (housing) there are 2 mounting bolts on top (covered)to remove, then pull out the assembly...
How do you change the headlamps in 2000 Mitsubishi Eclipse?
Locate the rubber housing of the bulb behind the headlight assembly and pull/disconect it. Unscrew all bolts. Lift and pull out the front part of the headlight assembly and replace the bulb making sure the contacts are aligned. Put back and bolt the headlight assembly and plug.
What stops a 2001 Mercedes C320 steering wheel from adjusting?
i assume its electric if u hear the motor making noise theres a rubber tube lookimng thing its called the transmission they break common replace the rubber tube and the motor the motor is faulty and that what breaks the tube
