Disconnect the cable at the battery. Trace the wire to the other end, looking at how it is routed. Disconnect the wire and pull out. Put the new wire in, routing in the same manner. Connect the cable ends back up.
Remove the positive battery cable from your 1988 Chevrolet 1500 pickup truck battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
Unfortunally you can't replace just the cables. They come with the latch assembly and there is a left and right.
You are in luck. GM has a recall on these cables and will replace them for free. Contact your local GM dealer.
Replacing a battery in a 2001 Chevrolet Tahoe is very easy to do. You will just need to take off the battery cables off the battery and put them to the side. Remove the old battery and replace with the new one. Put the cables back on the correct posts.
Clean the cables and bolts of all corrosion and tighten them so that the cables will not move. This will insure a good connection.jd
how do you replace a CV joint on a 1992 Chevy pickup?
disconnect the 91 blazer cables at the battery. One at a time, disconnect the cable at the opposite end, then pull it out. Put the new cable in, routing it the same way, then connect the non battery end. do the same for the other cable, then connect the cables to the battery.
how to replace a 1990 Chevy Beretta battery
how do replace a power steering hose on a Chevy c-1500 pickup truck
Remove the positive battery cable from your 1999 Chevy Astro battery. Disconnect the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
Disconnect the battery, remove the spark plug cables and boot covers, remove the old spark plugs. Next, put in the new spark plugs, replace the boot covers and cables and reconnect the battery.
Remove the positive battery cable from your 1993 Chevy Cheyenne battery. Remove the two cables from the front of the starter. Remove the three starter retaining bolts. Reverse the process to install the new starter.