Lift the plastic cover off by gently pulling upwards and back towards you at the same time. Under the cover you will see two 10mm bolts, one on either side of the light structure. Carefully remove each bolt, a magnet of some sort is highly recommended. Once the bolts are removed, you can lift out the assembly and twist out the bulb's connector and replace.
How do you replace the third rear brake light in a 2005 buick allure
How to change third brake light in 2009 Hyundai sonata
On my 1988 Conv the third brake light comes out through the license plate opening.The service manual suggests removing both the gas filler door and rubber boot along with the license.
Just unscrew the two screws holding in the red third tail light. Pull out assembly, replace bulb. 2003 Town & Country used a 921 bulb.
BMW servise
remove tail light and reach through
the screws come off and you replace it
Remove the two screws holding the third brake light lens on then remove the lens, it may be stuck but it will pop off. Replace the two bulbs in there by pulling them straight out.
Remove the two screws in the lens. You can remove the entire assembly once you do this.
The third brake light on a 2007 Toyota Avalon is replaced by first removing the rear, retaining screws. The wiring harness can then be disconnect and the light bulb removed.
the third brake light is direct from brake light switch no fuse
I just replaced a blown third brake light bulb today. ... I have about 60k on my M and havent yet had to change the brake light---so if it only has to be done once in the ... If memory serves, the Concorde's is in the rear window. ... Well I decided to mod my 2004 300Mspecial Third Brake lights, not with a bulb ...