I don't know if it is the same, but the lights were out in my 97 Chevy truck radio, so I took the radio apart (not a easy feat) and all the seaperate lights for the buttons are soldiered to the circuit board so I am assumeing they are not replaceable, unless I can find a radio store that can put new ones in.This Might help
Try this website it is already on the page you need. http://www.corvetteradios.com/corvetteradios_013.htm
it has the bults and a diagram of how to take the radio apart and do the soldering jobs, not the greatest but it is the only one i could find. also i am gonna try this with leds lights from radio shack and see it that works instead of paying 22 dollars for 10 lights. radio shack is like a dollar for 1 maybe two i don't remember
how do I replace interior light bulbs in 2002 chevy impala. I removed the cover, but the bulb is cramped in and I can't pull it out.
Most steering wheel buttons bulbs are not serviceable, you must replace the button(switch) or the shole horn pad, most dash and switch bulbs are not serviceable
You have to remove the instrument cluster to service the light bulbs.
Remove the screws that hold the covers in place. Replace bulbs!
http://www.corvetteradios.com/ sells the bulbs for the GM k1500 radios. They have a diagram showing how to solder them to the circuit board on their site.
The bulbs unscrew from the back of the light assy. sometimes you have to remove it to get to the back.
Open the rear hatch and you will see the retaining screws inside the door frame.You can then drop the light out to get access to the bulbs. If no bulbs are bad then you may have a bad circuit board.
The # is 1157 bulbs.
If the turn signal bulbs light but will not flash, the flasher relay is defective, replace it.
Yes, you can replace ordinary light bulbs with an LED.
If the left or right bulbs light up but don't blink, replace the flasher. If none of the bulbs light up, check the fuse. If one or more bulbs are not lighting up, replace the bulbs.
Replace your 75-watt light bulbs with 40-watt light bulbs!
How to replace passenger side head light bulbs in a 2000 Honda Accord?
To replace the brake light bulbs on a VW Polo, pull away the carpeting in the trunk, unscrew the bolt holding the lights on, and disconnect the wiring. Replace the bulbs, put the wiring and bolts back, then replace the carpeting.
How do you replace a break light switch on 1995 Chevy Tahoe
For lights behind the speedometer/tach warning light area, you have to take the screws out of the panel and then guide it out enough that you can twist it sideways and pull out the burned out bulbs. Replace with bulbs #194 and I would use the Long Life version of the bulbs.
Bad light bulbs.... Replace them...
you got to replace to light bulbs
To replace the parking light bulbs, remove the screw on top of the headlight and pop out the clearance light. The parking light bulb will be accessible after this removal.
the whole light or just he bulbs?? just the bulbs
Remove the two screws holding the third brake light lens on then remove the lens, it may be stuck but it will pop off. Replace the two bulbs in there by pulling them straight out.
Open trunk and remove panel at rear, remove butterfly bolt and tail light assembly should pop out for accessibility to bulbs
There are no individual bulbs, just LED's in the dials, and you will have to replace the entire instrument cluster.
You have to remove the instrument cluster to get access to the bulbs.