there is a 3 wire sensor bolted to the front cover of the engine. use a 10mm socket and remove the bolt. after unpluging the sensor carfully rotate the sensor up and down in order to loosen it from the engine. then pull out
The P0336 fault code on 1997 Buick Lesabre is a fault in the crankshaft position sensor circuit.
under the water pump.
Replace axle on 2001 buick Lesabre
how do you replace the fuel pump on a 1997 buick lesabre
The 2000 Buick Regal 3.8L Crankshaft Position Sensor is located behind the harmonic balancer pulley.
throttle position sensor believe it or not!
where do the thermostat go in my 93 buick lesabre
Don't think yours will have a MAP sensor. It will have a MAF sensor, and it is attached to the air filter housing.
The interrupter magnet is normally replaced by removing the camshaft gear as the magnet is inserted through the back side of the gear.
How do I replace heater core on 98 Buick lesabre
how much would it cost to replace the heater coil on a 1999 buick leSabre
The Crankshaft Position Sensor is behind the crankshaft pulley (harmonic balancer). You will need a ½-inch drive breaker bar and appropriate socket.