0
How do you replace the clutch slave cylinder on 1999 Hyundai accent?
Wiki User
∙ 10y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you replace a clutch Slave cylinder on a 2001 Hyundai Accent?
Take it off
What is the cost to replace a clutch on a Hyundai Accent stick shift?
I have been told by Hyundai services that it would cost me $950 to replace the clutch of my 2000 Hyundai accent. I think this is a reasonable price.
How do you replace clutch fork on a 2000 Hyundai Accent?
Fork
How do you do a clutch adjustment on a 1999 Hyundai accent?
A 1999 Hyundai Accent does not have a clutch adjustment. The clutch pedal however, can be adjusted to a different height.
Clutch fluid leaking on the ground on a 1997 Hyundai?
your slave cylinder is leaking,need to replace.
Where do you add clutch fluid on your 2001 Hyundai Accent?
There is a reservoir on the clutch master cylinder, mounted to the firewall toward the driver side. It's got a black cap.
How do you replace the slave cylinder on a 1995 dodge neon clutch?
How do you replace a slave cylinder on a 1995 dodge neon clutch
How do you replace the clutch slave cylinder on a 1989 Jeep Wrangler?
How do you replace the clutch slave cylinder on a 1989 jeep wrangler
Where is the Hyundai accent clutch switch?
The clutch switch is right under the dash board under the clutch it is a long tubular looking switch that pushes in and out
Should you replace your clutch master cylinder when replacing clutch?
At least the slave cylinder. The clutch master cylinder can be replaced at any time.
What could go bad in a master cylinder for a hydraulic clutch on a 1991 Hyundai Accent?
Usually the rubber seals go bad. On the other hand, if you live in a very humid area you might have a little water in the hyudraulic fluid and it could have rusted the master cylinder. They aren't usually terribly expensive to replace if you do it yourself.
Can you do a clutch repair on a Hyundai Accent?
If adjustable, otherwise replace. Hyundai vehicles use a hydraulic clutch set up which are not adjustable. When replacing the clutch do not machine the flywheel; this changes the clearances and will cause clutch engagement issues. Inspect flywheel for cracks or heat related damage, if none sand using 3M sanding disk or equivlent, if there is damage replace flywheel. Note: I believe the torque specs on the pressure plate are 12-16 ft-lbs.
