You must replace the crankshaft sensor very carefully. There is a small bolt that holds it in place on the back side of the engine,(usually an 8mm socket does the trick)you can access that bolt by reaching under the car between the transmission and the engine. when that bolt is out you must twist and pull the sensor at the same time. If you have a problem getting it out you can use a screwdriver to start to pry it out but becareful not to break it. If you break it and it is still in the engine block you will need to drop the oil pan and pound it out from the bottom.
I may sound crazy, but i had an easier time with the sensor after i removed the coolant tank, the alternator and the alternator mounting bracket. You will get an almost straight shot from above especially if you jack the engine up a few inches. Though it is best to spot its position from the bottom so you know where to put your hand.
It is on the accelerator pedal. You have to replace the whole pedal assembly
The Pontiac Grand Prix was produced from the years 1962 to 2008. The throttle position sensor in a 3.8 V6 Pontiac Grand Prix is located on the butterfly spindle of the throttle body.
Where is the throttle position sensor on a 1997 pontiac grand am 4 cyl.
there isn't a crankshaft position sensor on a 3.8l motor in a 1999 Pontiac grand prix according to the manual
The camshaft position sensor on a 1998 Pontiac Grand Prix is located behind the rear bearing of the camshaft. It constantly monitors the rotation of the camshaft and relays this information to the computer.
The camshaft sensor on a 1993 Pontiac Grand Am is located behind the rear bearing cap. It detects the position of the camshaft as it rotates and relays this information to the computer.
How do i fix the TPS pedal position sensor in a grand prix pontiac 2004.
were is my 1999 pontiac grand am map sensor location
most likely you will have to replace the hub bearing assembly autozone for about $80
Losen the exhaust cross over and take off temp sensor
Some place in the world i think
Cooling fans won't stop running in the cold on a grand am gt 2001
The 1999 Pontiac Grand Am AIT sensor is located on the outside of the air filter housing. The sensor will be on the back of the housing.
Check the 2001 Grand Ams crank shaft position sensor first. If the sensor is bad then the engine will not get fire or start.
right above the oil filter
How do you replace starter on2.3 cy 1991 pontiac grand am
Usually the Throttle Position Sensor is located by the intake manifold, usually at the end of your air intake.
were is the crankshaft sensor located on a 1987 Pontiac Grand AM with a 2.5L engine
These fans work off of heat sensors. Your sensor can be failing, replace this sensor. This still does not tell where the sensor is located.
how do I replace water pump 2000 Pontiac Grand AM SE1?
location knock sensor 2002 pontiac grand prix gt 3.8 engine
how to replace lifters on a 03 grand am
Is it hard to remove / replace the sensor Speed sensors are located on the front wheel hub
It is located on the drivers side of the crankshaft pulley. The shop time to replace it is 1.4 hours and the part is about $80. It would be around $225 to have the dealer replace it.