Dashboard Lights and Gauges
Chevy Impala
Mercury Mountaineer

How do you replace the dash light behind the speedometer in a 1998 Mercury Mountaineer?

646566

Top Answer
User Avatar
Wiki User
Answered
2015-07-15 19:41:14
2015-07-15 19:41:14

the instrument cluster has to be removed to gain acces to the bulbs .the lower trim under the steering wheel has to be removed.theres 2 peices,one plastic one metal.then you remove the radio bezal,2 screws above the climate switches.then remove6 screws retaining the inst.cluster cover.4 screws retain the cluster,the shift indicator has to be removed from the cluster. disconnect 3 or 4 wire connectors.and pull cluster out.flip upside down and there should be 6 large black bulb sockets turn counter clock wise and remove.i would suggest replacing all 6 bulbs.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


On a 1997 Mercury Mountaineer : The fuel pump shut off switch ( inertia switch ) is in the front passenger footwell , by ( or behind ) the kick panel

The cabin air filter on a Mercury Mountaineer is located on the passenger side of the vehicle. The unit is behind the glove box and can be replaced by removing the glove box.

Is it the fan behind the radiator, or the fan that blows air into the cabin?

In the front passenger footwell , behind the kick panel

According to the 1999 Mercury Mountaineer Owner Guide : The fuel pump shut off switch ( inertia switch ) is in the front passenger footwell , behind the kick panel

According to the 1999 Mercury Mountaineer Owner Guide : The fuel pump shut off switch ( inertia switch ) is in the front passenger footwell , behind the kick panel

its behind the panel on the passenger side behind the seatbelt on a black box its 5 digits

The fuel pump shut off switch ( inertia switch ) is in the front passenger footwell behind the kick panel on a 1999 Mercury Mountaineer

behind the jack compartment. twards the back passenger door

Not by back passanger side tire. In front of the gas tank behind a heat shield.

jack up car and change plugs from behind each front tire.

The computer module in a 2003 Mercury Mountaineer is located behind the rear right panel in the truck space. The rear right seat belt panel must be removed and then the lower panel. The module is located beneath a green plug.

For the 1997 to 2001 Mercury Mountaineer : The Powertrain Control Module ( PCM ) is located in the engine compartment . You will see where the wiring harness is bolted to one end of the PCM . It passes through the firewall ( most of the PCM is " hidden " behind the glove compartment area

Behind the drivers side rear quarter panel in the cargo area

The Data Link Connector should be in the lower part of the dash , below the steering wheel , between the inside hood release and the emergency / parking brake release ( it's behind a small removable plastic panel ) on a 1998 Mercury Mountaineer

The owners manual shows that it is in the right front passenger footwell , behind the kick panel

On a 2001 Mercury Mountaineer : The air suspension switch which is turned OFF any time a wheel is off the ground ( is located in the cargo area , on the drivers side , near the liftgate , behind the removable plastic panel where the wheel jack is stored )

Usually it is near the left kick panel behind the fuse box. Sometimes it is mounted on the right side of the vehicle.

It is located on right side behind the side kick panel in the front passenger's side.

In the front passenger footwell , behind the kick panel need picture of fuel rest

You can't you have to replace the whole dashboard instrument cluster assy.

For the 1997 to 2001 Mercury Mountaineer : If you open the drivers door , you will see the removable plastic fuse panel cover in the drivers END of the dash . The fuses are behind the cover * also , the Power Distribution Box ( which is " live " ) is located in the ENGINE COMPARTMENT on the drivers side of the engine compartment

On a 1997 Mercury Mountaineer : Open the drivers door and in the drivers end of the dash you will see a removable plastic fuse panel cover . The fuses are behind the cover Also , the power distribution box ( which is " live " ) is located in the engine compartment , on the drivers side , near the firewall

On a 1999 Mercury Mountaineer : The Powertrain Control Module ( PCM ) is in the engine compartment , passing through the firewall . From the engine compartment , towards the passenger side of the engine compartment , you will see where the wiring harness is bolted to one end of the PCM at the firewall ( most of the PCM is " hidden " behind the glove compartment )


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.