answersLogoWhite

0


Best Answer

Diaphram? I'm not sure what part you are talking about. Normally replace the fill valve with a Fluidmaster 400a, new supply line, and the flapper with the proper one for your toilet.

User Avatar

Wiki User

โˆ™ 2006-05-09 11:59:22
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace the diaphragm in a toilet?
Write your answer...
Submit
Related questions

How do I fix a Zurn Urinal that won't stop running after I flush?

Replace the diaphragmReplace the diaphragm


My toilet does not flush well. Is there any way to fix it?

A common reason for his problem is that the diaphragm is worn and not lifting enough to create a siphoning action. The easiest way to fix this is to drain as much water as possible around the siphon, and then either replace the siphon or take it off and replace just the diaphragm.


How do you replace a flapper in a toilet?

Shut the water supply off to the toilet. Flush the toilet. Pull the old flapper out and replace it with the same type. Turn the water back on and test the toilet.


Why does my toilet make a whining noise after it's flushed?

faulty ball valve change the diaphragm washer faulty ball valve change the diaphragm washer faulty ball valve change the diaphragm washer


How do you replace toilet parts?

easily!


How much do plumbers charge to replace the toilet kit?

Most plumbers would charge 2 hours to replace a complete toilet.


How do you fix a leaky toilet?

Where is it leaking ? Flapper in the tank, replace flapper. Between tank and bowl, separate and replace the seal. Toilet to floor. Replace the wax ring under the toilet, making sure it is thick enough to form a seal and the bolts are installed correctly and holding the toilet down.


Where is the diaphragm washer in a toilet?

seal to stop water from runing into tank located between tank and bowk


How do you fix a 1994 Nissan Sentra manual transmission that you can shift into all gears but 4th?

replace your pressure plate (diaphragm type), and the clutch. replace your pressure plate (diaphragm type), and the clutch.


When remodeling the bathroom does the ceramic floor get installed first or the toilet sand vanity?

You can install the vanity first. Then, install the tile up to the vanity and around the pipe for the toilet. Then, install the toilet. That way, you do not have to replace the tile should you ever have to replace the toilet.


What should you do when a the tip of the toilet auger break off in the toilet?

Remove the toilet from the floor, locate the broken tip, and replace the toilet. Don't forget the new wax ring.


How do you change an old toilet to a close coupled toilet?

You replace the toilet as a whole item. You cannot take a tank from one type and put it on another.


Can you buy and repace the diaphragm in your furnace gas valve?

No, you should replace the valve.


How do you replace the toilet shut off valve?

With two wrenches


What can you eat to replace eating toilet paper?

paper towels


How do you fix singing toilet?

Just replace the ballcock valve..


How do you replace a broken toilet tank lid- Do I have to purchase the same brand replacement lid from salvage or is there another way to replace the lid without getting a whole new toilet?

As far as i know, you cannot buy just the toilet lid. Either you can ask at certain scrap dealers or you will have to buy a new cistern, if only it is a low level. Otherwise if it is a close coupled sytem you will have to replace the entire toilet.


Why is there a foul smell by the toilet?

You may need to replace the wax seal under the toilet. It isn't difficult to do, but will take a lot of time.


Can you fix a wobbly toilet?

Maybe. It will depend upon why the toilet is wobbly. It could be simply taking the little 'caps' on the base off and tightening up the bolts that are there. If one of the bolts is broken, you can replace the bolt, which would allow you to tighten it up. It it is because the floor is rotted out under the toilet, you would have to remove the toilet, replace the sub-flooring and reseat the toilet. Replacing the wax seal may also help. If the toilet seat ring on the sewer pipe is broken, it will take an experience plumber to replace it and set it up correctly.


Water pressure surges when flushing toilet?

Replace the fill valve.


How long does it take to replace a toilet?

It takes about 10 or 11 minutes


How hard is it to replace a toilet.?

It's fairly difficult as you need to replace a seal thing and turn the water off.


Why is there a metallic earthy smell coming from my toilet area?

The toilet wax ring is probably cracked and leaking.You have to drain and remove the toilet to replace the wax ring below it.Hope this helps!


Should the landlord replace toilet seat before a new tenant in new York?

Not necessarily: it depends on the condition of the toilet seat. If the landlord wants to attract a new tenant to rent his property to, it would be best for him to replace the toilet seat if it's not in good shape, because one of the worst detractors of tenants is a broken toilet seat.


Why would the basement toilet produce a bad smell but there is no clog?

Take the toilet off and check the WAX RING..replace the wax ring