Best Answer

It is very hard to do but you will need a 12mm socket for the alternator and a long 12mm wrench to loosen the bolts on the other pully and a 10mm Allen wrench to adjust the A/C belt

User Avatar

Wiki User

โˆ™ 2011-09-12 20:55:35
This answer is:
User Avatar
Study guides
See all Study Guides
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you replace the drive belts on 2000 Suzuki Grand Vitara when the cooling fan blades prevent using a socket on the tension pulley?
Write your answer...
Related questions

How do you replace the dome light on a suzuki grand vitara?

to replace dome light in suzuki grand vitara

How do you release the tension to install the serpentine belt on a suzuki aerio?

15 mm wrench Put it on the tension pulley and pull to take tension off belt

How do you remove the cooling fans in a 2007 suzuki xl7?

Very carefully

Where is the thermostat on a 2000 suzuki grand vitara?

replace thermostat suzuki gran vitara 2000

How can you replace rear wheel bearings on a 04 suzuki XL-7?

how can you replace fron wheel bearings on a 2002 suzuki xl7 4 wheel drive

How do you replace a ball joint on a suzuki vitara?

This is the first time for me to work on a Suzuki and I can't seem to get the head off to replace the gasket or to see if the head is cracked is there a trick to removing the head on a 2001 Suzuki esteem 1.8 with dual overhead cam

How do you fix the transmission range selector on a 2007 Suzuki?

You replace.

How do you replace piston rings on a Suzuki FA50?

you bring it to a shop

How do replace a speedometer cable on a Suzuki samurai?

how to un hook

How do you replace front turn signal bulb on suzuki?

To replace a front turn signal bulb on a Suzuki, refer to the owner manual for instruction. The manual gives diagrams, and instruction to the owner about the vehicle.

How do you replace a transmission filter for a suzuki aerio?

How do you replace a transmission filter for a suzuki aerio SX 2006 ?Read more: How_do_you_replace_a_transmission_filter_for_a_suzuki_aerio

How do yu replace the headlight bulb for a 2006 suzuki grand vitara?

To replace a headlight in a 2006 Suzuki Grand Vitara first open the hood. Prop it safety up and locate the headlight housing. Remove the bulb from the housing and replace the unit.

When should the timing belt be replaced on a 2004 Suzuki Grand Vitara?

When do you replace the timing chain on a 2005 Suzuki Grand Vitara?

How do you replace the ac clutch on a Suzuki Aerio SX?

You will have to replace the compressor unit. You should b e able to find non/Suzuki unit for about $500. Dealer price: $1,700 parts and labor.

Where is the Location of ignition coil 2004 suzuki Verona?

They told me that i needed to replace the ignition coil on my 2004 Suzuki Verona, my question is how do i know which to change because i just found out the are 6 of them. Do i have to replace them all?

How do you replace headlights 2000 suzuki esteem?

Dont buy one

Where to Replace freon in 2001 suzuki Grand vitara?

Behind the grille

Free repair manual for a suzuki 2006 c50 boulevard?

I need to know how to replace a left front turn signal on my Suzuki C50T?

Is anyone smart enough to tell me how to replace fuel pump on 99 suzuki vitara?

1999-2004 suzuki vitara total service manuals - chilton

How do you do a tune up on a 1995 suzuki sidekick?

Replace the spark plugs and plug wires. Replace the distributor cap & rotor. Replace the air & fuel filter.

How do you replace timing belt on a suzuki alto 1.1?

Pl go to the Automobile section

Where is the cooling fan switch located on a suzuki boulevard c50?

The switch is located at the bottom of the radiator right next the the rubber hose.

Where does the clutch fluid go in 95 suzuki sidekick?

Suzuki Sidekick has a cable for the clutch. No fluid required. If it hard to push or seems to 'stick' then replace the cable.

Where is the cooling water indicator on Suzuki DT 8 outboard motor?

The year model of your engine is not mentioned here, but the only two places that I have seen them located on the 8hp Suzuki is in the cylinder head, about midway up, and in the exhaust cover.

How do you replace Suzuki fork seals?

Basic fork replacement guide, works for my 89 RM250