I had this problem,I found it was not lamps At Fault,It was a broken wire in wiring loom
inside mirror (white wire)
You dont. Take it apart by popping the buttons off and clean it with a qtip and a little bit of rubbing alcohol
how do I install the small part that holds the sun visor in place. I have new parts and don't know how to take apart the original sun visor.
on my 2002 picasso its located on the nearside wing mirror, look underneath the mirror and you will see a little bump, that is the sensor, you can take the wing mirror apart to get to it but if you have pranged your mirror lately it can becomw faulty
Things Fall Apart recreated much of the typical scenarios of Nigerian lifestyle before and during colonization.
You will find it if you remove the lower cover that houses the indicator/wiper stork that is underneath steering wheel, just remove 2 screws and pull covers apart.
Locate the triangle-shaped mirror cover on the inside of the door. It's opposite the mirror housing. Remove the cover by pulling it off the door. Disconnect the wiring harness by pulling the two connectors apart. The harness was hidden by the cover. If you are replacing the passenger side mirror and it is not powered, skip this step. Remove the three nuts that secure the mirror to the door, using a 10-mm socket and ratchet. Pull the old mirror out of the door and slide the studs of the new mirror into the door. Be careful not to scratch the paint with the metal studs. Bolt the mirror onto the door with the three nuts. Reconnect the wiring harness by pushing the two connectors together. Place the plastic mirror cover on the door and push it into place with your hand.
i just had this problem with my 93 probe, the rear view mirror fell off. i couldn't get mine apart either. I went to pepboys and they said there's a clip that you can't get to, but pepboys does sell a "button" all by itself. It' was like $4. Buy that. It takes about 5 minutes total to put it on. You'll just attach the new button to the windsheild, and the old rear view mirror to that.
take apart and clean copper contacts, no need to replace.
Well, All depending on what your fuel filter is for, you cant take it apart, you just have to replace it.
Where can you find instructions for taking apart the hub to replace rotor on ford bronco xlt 1995
If it's anything like my 87 was (and it should be, they're basically the same car from 87 to 91), you have to take apart the door panel so that you can get the little plastic cover for the mirror off, where you can then get the screws off. There's also a little white plastic clip in there, just squeeze those with some pliers to get it off.
You have to take half the car apart to replace the heater core