0
How do you replace the fan clutch on a 1997 Chevrolet S10 pickup?
Wiki User
∙ 18y ago
Usually there are 4 nuts holding the clutch and fan on to the water pump shaft. Just pull the nuts, remove the fan clutch and replace it.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
How do you replace the hydraulic clutch line on a 1997 Chevrolet S10 pickup?
how do you replace hydraulic line on a 1997 s-10
Replace fuel pump on a 1500 series 1997 Chevrolet pickup?
Drop the fuel tank.
Can you switch the computer from a 1997 Chevrolet pickup to another pickup?
sure,especially recommended for a ford
How to replace the clutch in a 1997 Nissan pickup 4x4?
Get your local mechanic to do it on off time. This is such an easy clutch job it'll take about 30 minutes so you can expect a perfect result at low cost.
What is the difference between a 1997 Chevrolet c series 2500 pickup and a 1997 Chevrolet cheyenne 2500 pickup?
Cheyenne is an accessories package, timr, lighting, cigaretter lighter, seat covers, etc
In 1997 did Chevrolet offer 2 wheel drive in Z 71 pickup?
No
What is the cost to replace the clutch in a 1997 Ford Escort?
It will cost approximately $450 to replace the clutch in your 1997 Ford Escort. The clutch will cost approximately $200 and require four hours of labor to install.
How do you replace the clutch cylinder slave in a 1997 Chevrolet S10 pick up?
Replacing the clutch slave cylinder requires removing the transmission assembly. I would recommend purchasing a shop repair manual for that vehicle if you intend on DIY.
Can you switch computer from 1997 Chevrolet pickup to another pickup?
AS LONG AS PART NUMBERS ARE SAME . ITS DONE BY AUTO WRECKING YARDS .
How do you replace the clutch in a 1997 Nissan Pathfinder?
get a mecanic to do the job
How do you adjust a hydro clutch on a 1997 Chevy 1 ton?
YOU CAN"T, There is NO adjustment, Time to replace the clutch
How do you remove a fan clutch on a 1997 S10 pickup 2.2L?
The fan clutch on a 1997 S10 has a bolt on the center of the front. Remove the bolt while holding the clutch still. There is a special tool to grab the clutch fan from the rear to hold it while removing the bolt.
