0
How do you replace the freeze plug on the head on a 1989 929 Mazda?
Wiki User
∙ 15y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you replace the head gasket located on a 1989 Mazda B2200 1.3L?
replace head gasket
What is the cost to replace the head gasket on a Mazda MPV?
What is the cost to replace the head gasket on a Mazda MPV?
How do you remove the head and replace a head gasket on an 1984 Mazda B2000?
take it to a pro
How do you remove head light assembly from body Mazda 323 SP20?
replace headlight on mazda sp20
Where is the freeze plug located in a 1988 Mazda 323?
There are multiple freeze plugs for these motors. From memory ther are 3 freeze plugs located down the each side of the block and possibly one located on the head.
Ticking noise in a 1989 Mazda mx6 gt turbo?
it is the lifters, so you will need to change the head
How can you repair the temperature gage that stopped working on 1989 Mazda 323?
It is probably just the sensor. The sensor will be on the head or around the thermostat housing. If you ground the wire attached to the sensor to the head, the gauge should go to hot when you turn the key on to the Run position. That will confirm that the sensor is bad and you just replace it.
What Head bolts do you need to replace head gasket?
Where can i order Head Bolts for a 1998 Mazda 626 2.0L? Try your local auto parts stores. If you strike out with them, try the Dealership.
How do you replace head light Mazda b3000?
take old one off and put new one on, hope this helps
Where do you find the freeze plug on an 1989 Isuzu pickup truck?
there is more than one freeze plug. there is about six in the block and a couple in the cylinder head(s) depending on if it is a 4 or 6 cylinder.
What is the easiest way to replace the freeze plug in the rear of the head on an F series truck with the 300 CID 6 cylinder?
Your back freeze plug isn't on the head but the block. And a real B**** to change. Jack it up and unbolt the bell housing to get to it.
How do you replace a cylinder head gasket on a Mazda b2200?
The intake & exhaust manifold must be removed, then the head is remove. Head inspected for cracks and warpage, all gaskets replaced and all parts reinstalled.
