if it's anything like a 92 skylark you have to get the window down far enough (if the motor is dead you can usually turn it manually) to get to the two bolts that hold the window on. Remove the bolts and push the window up. It may have to be held there with some strong tape. if you see bolts holding the motor in then great! remove the motor and the actuator in one piece. If there are rivets then you need to drill out these rivets with a drill not much bigger than the inside part of the rivet.( don't worry the new motor will come with bolts). very carefully switch out the motors on the actuator making sure to have it in the same position. Also, the motor might be riveted to the actuator so the same thing applies to this as well.then replace the motor and actuator then reattach window. on a scale of 1 to 10, with 10 being the hardest i would rate this a six.
how do you replace the alternator in a 97buick skylark
Do you mean the main switch by the driver or the switch on the door itself?
How do you replace the water pump and where is it located on a 1996 Buick Skylark V6
you replace it by...hold on
how do you replace a ignitionswitch tumbler 1991 buick skylark
can i do this at home
The 1997 Buick Skylark computer is located behind the passenger side dashboard. You will need to remove the passenger side kick plate in order to access the computer.
I think it was 1971.
Ignition what? Switch? Coil?
The low side AC port on a 1994 Buick Skylark is on the passenger side of the engine compartment. It is near the front of the oil pan.
will the fenders from a 1971 Buick Skylark Custom fit a 1972 Buick Skylark?
I think it's on the passenger side. A lot of debris can get in there.