I was trying to replace the rotors myself yesterday, when I couldn't figure it out I called my Uncle who is a mechanic and the following is what he said to do. Once you have taken the wheel, caliper and caliper bracket off, you are left looking at (from the inside out) A black metal cap, a small hub attached to a large hub, and the large hub is attached to the rotor. Use the end of the lug wrench to remove the black cap (you will probably bend it). There is a snap ring around the axle, remove it. Then undo the 6 nuts on the small hub and tap that with a hammer and a pry it off with a small flat head screw driver. Once that is off you will see 2 small screws that hold a metal piece on to the nut behind it, remove the screws and the metal piece. Next there is a round nut with 4 small screw holes and 2 larger holes remove that piece as well. Then pull the rotor off, careful because the wheel bearing is in there and may fall out. Remove the large hub from the rotor and put in on the new rotor, put the wheel bearing back in and put the rest together. Try to keep everything in order as you are taking it apart to help coodinate exactly how to put it back together. I did this over the weekend, the first side took me about an hour and a half, the second side about 45 minutes. Hope this helps.
lots, replace pads and shims, clean and pack wheel bearings with grease and replace grease seals, resurface/replace rotors
use new pads and shims, repack wheel bearings and replace grease seals, set factory bearing tension, and resurface/replace rotors.
The best way to replace a door window on your Infiniti QX4 is to take it to a dealership that specialized in repairs for the Infiniti. Your car may still be under warranty, and may be able to be repaired by factory trained mechanics.
1200-1500
where is the IAT sensor located on 99 qx4 infiniti
Behind the battery on front (L)eft side.
How many quarts in an infiniti qx4 97
most of the time you can tap on the front motor under the seat, lower front and it will work temporary you must pull seat out to replace motor
disconnect lines and hoses and remove fasteners
There are two O2 sensors for the 01 QX4. One in front of the catalytic converter and other is behind the converter.
alldata puts it at 5.0 hours
junkyard