If you can't get to the rear of the light you may have to take the light off and the bulb just turns clockwise to remove it.
. I had to use the JACK to slightly lift the vehicle up enough for me to get my BIG head under the left front corner and look up into the bumper area. I removed 4 plastic push/pull TABs (that look similar to screws). I first removed 2 push/pull tabs that hold the lowermost horizontal plastic protective cover (black in color) to the adjacent front bottom bumper protective plastic. I also removed 2 push/pull tabs that fasten the same lowermost horizontal plastic protective cover to the adjacent 'wheel side' protective cover near the internal fender cover. This allowed me to then bend and mold the horizontal black protective cover up toward the hood so I could view the inner portion of the plastic bumper where the electronic connector (bulb) inserts into the yellow front blinker housing. I twisted the connector and it pulled out giving me access to the bulb. I purchased a new bulb, protective coating jell, coated the connector and replaced the bulb. Re-installed the connector, twisted it into place and reassembled the protective covers and re-inserted the push/pull tabs. Worked great and was very easy.
Replace axle on 2001 buick Lesabre
How do you replace the front turn signal bulb located on a 2001 Buick Century?"
how do you replace the fuel pump on a 1997 buick lesabre
Where is the a Alternator located on 1999 buick lesabre
replace the combination switch on the turn signal stalk
where do the thermostat go in my 93 buick lesabre
Bulbs or turn signal flasher, maybe even the switch.
Where is the thermostat located on a 1987 Buick LeSabre?
where is the engine controle module located in a 1995 buick lesabre
How do I replace heater core on 98 Buick lesabre
how much would it cost to replace the heater coil on a 1999 buick leSabre
Located in fuel tank - remove tank to access