The Mazda truck was sold to Ford. It is under the driver side door and mounted to the inside frame. It has two clamps to hold the gas line, and maybe a bolt or two depending on the model. If you choose to replace this use caution! the gasoline will probably flow out!
Actually, My '96 B2300 was MADE by Ford for Mazda.
One thing you should do is to take out the fuse for the fuel pump, and then run the engine until the line is empty. This will rid all pressure in the line, which is needed on fuel injection systems. The fuel will drain out, but will not spray all over you. My truck has an inline fuel filter that must be removed with line wrenches, so be sure to find which type is on your vehicle before purchasing a replacement. After replacement is done on a fuel injection vehicle, you may need to purge the air from the line. This is accomplished by pressing and holding the relief valve on the injector rail. It looks like a tire stem valve, and the valve is opened the same way as letting air from your tire. Get an assistant to crank the engine while you hold the valve open. Wear gloves while doing this procedure, and when fuel comes out of the valve (you may want a fuel-resistant container to catch it), stop holding the valve open. The engine should then start, and flush any remaining air on its own.
Note: You may need to reset your "check engine" light after this, but many parts places like Advance Auto do this for free.
Good luck.
Where exactly it the fuel filter located on my 1996 Mazda protege 1.5 motor.
Where is the PCV Valve on a Mazda B2300 2003
On a 2001 b2300 it is located above the transmission and you have to take part of the transmission out to get to it. It cost me 538.00 at the Mazda dealer!!!!!!!!!!!!!!!
how du you replace a thermostat in Mazda pickup b2300 94
Just replace it every 36,000 miles and you will know it is not clogged.
You didnt specify what year.i have a 94 b2300 and had to replace the grill and in order to replace i had to take the front bumper off just to get to dome of the screws.so be prepared.
A mazda dealership told me that it didnt have one when i asked to replace it. But i am skeptical
take the gas cap off
Wiring diagram for 96 Mazda b2300
stand at the front of the car and look for the top rad hose and follow it to the end there should be two bolts holding the hosing unbolt and replace the thermostat and gasket
what is the torque of an upper balljoint on a 2003 Mazda b2300.
I found the owners manual for the 2003 mazda b2300 and it shows the fuses and what they are. http://www.manualowl.com/am/Mazda/2003-B2300/Manual/798