ITS LOCATED INSIDE THE GAS TANK, YOU HAVE TO REMOVE THE TANK ITSELF. I don't Think That's the correct answer. I believe the pump is in the tank, but it's verry easy to remove. Open the tank lid and remove the bolts on the plate around the filler tube. Dosconnect all the fuel and vent hoses and lift the plate straight up. the pump, filter and assembly are on the bottom of the suck tube.They will all come out in one piece.
fuel pump relay located on the engine compartment firewall driver side. The fuel pump relay is located under the dash on the passenger side of the 1986 Corvette. Their are 2 under that location one is the overdrive relay and the fuel pump relay. Devyn (
Where is the fuel pump fuse on a 1989 corvette
how to change a fuel pump in a 1998 Chevy Corvette
To replace the fuel on a Toyota MR2 the gas tank will have to be drained and removed. Locate the mounting hardware and drop the tank. The fuel pump is located on top of the tank disconnect it and replace the pump.
the fuel pump is located under the fuel lid remove the lid and you will see a square plate with bolts remove bolts and pump sender comes out change pump then reassemble
= Where is the fuel pump reset switch on a 1989 corvette automatic? =
I just changed Mine just recently,,1985 corvette fuel pump is in the fuel tank,
remove fuel door, rubber boot, and then sender bolts at fuel fill. pull unit up and out. fuel pump is on the end of the pickup tube in tank.
Fuel injected? in the fuel tank Carb.? look at the lower front section of engine
Gas door is on the deck lid.
No you do not.
The 1987 Chevy Corvette fuel pump fuse can be found in the fuse box. The fuel pump fuse will be in the second column, third from the top.
The fuel pump on 1980 Corvette is found at the centre of the engine. This is usually adjacentÊto the fuel injector and the oil filter in the engine.Ê
1. Disconnect the fuel lines. 2. Remove the bolt on the front right face of the engine block which is opposite (just forward of)the front (forward) fuel pump mounting bolt. 3. Replace this bolt with one that is 2 in. or longer and snug it down. This will hold the fuel pump pushrod in place. 4. Remove the fuel pump mounting bolts and remove the fuel pump. 5. Replace the fuel pump, replace the longer bolt on the front of the block with the original and connect the fuel lines.
next to the fuel pump
Drop the fuel tank or unbolt the bed and slide it back enough so you can access the pump.
take the fuel lid door off and thake the filler tube up the pump is at the bottom of the fill tube tht is where you put your gas in
Yes, you do.
You will need a fuel pressure guage to check the fuel pump. The pump operates at 13 psi.
The fuel pump is mounted on the side of the engine block. Follow the fuel line from the carburetor backward and you will find the fuel pump.