Replacing the head gasket on any vehicle is a long and complicated process, however if you wish to see basic step-by-step instructions go to the related question on the right side of the page "How do you replace a head gasket?"
how do you replace the valve cover gasket on a 2002 mitubishi lancer
md349347
To replace the water pump in a Mitsubishi Lancer, start by disconnecting the negative battery terminal and draining the coolant. Remove the timing belt or serpentine belt, followed by the water pump mounting bolts. Carefully take out the old pump, clean the mounting surface, and install the new pump with a new gasket. Finally, reassemble everything in reverse order, refill the coolant, and check for leaks.
On a 2002 Mitsubishi Lancer 2.0, the transmission filter is located inside the transmission oil pan. To access it, you'll need to remove the transmission pan, which involves draining the transmission fluid and unbolting the pan from the transmission housing. Once the pan is removed, you can replace the filter, which is typically mounted inside the pan or directly on the transmission itself. Make sure to use a new gasket when reassembling the pan to prevent leaks.
To replace the water pump on a 1993 Mitsubishi Lancer, start by disconnecting the battery and draining the coolant. Remove the drive belts, timing belt cover, and timing belt if necessary, following your service manual for specific instructions. Take out the old water pump, clean the mounting surface, and install the new pump with a new gasket. Reassemble by reversing the disassembly steps, refilling the coolant, and checking for leaks.
up your but and around the cornner
replace head gasket
Replace it which is a major repair.
depends on how you take care of it. I have 155,000 on mine and have had no issues except for a leaky valve cover gasket which was fixed 60,000 miles ago.
On a 2001 Mitsubishi Mirage, the transmission filter is typically located inside the transmission pan. To access it, you'll need to remove the transmission pan, which involves draining the transmission fluid first. Once the pan is off, you can find the filter attached to the valve body. Be sure to replace the gasket when reassembling the pan.
remove old thermostat and replace with new thermostat and gasket
located at the end of the upper radiator hose. remove two bolts, replace with new parts remember to replace the gasket.