i have a 90 240sx and it was pretty simple first you remove the housing by taking the screws out (make sure u unplug the automatic lights)then crank them up to the highest by taking the caps off of the pump sort of pry at the plastic housing and lift it up and tward you. after that unscrew the metal support that attaches it to the car pull the light out and unplug it from the back get a new light and go backwards
ask the mechanic from the Nissan company
All starters on 240sx are located on the transmission. plain and simple with two long bolts.
Your TPS will be located on the throttle body.
its inside the windshield washer fluid tank, you have to remove it to access the pump
no it will not. To fit 97-98 headlights onto a 95-96 240sx you will need these 97-98 240sx parts: headlights hood front fenders front bumper front grill maybe the front bumper support
The Nissan 240SX was brought to America in 1989.
To replace the headlight motor on a 240 SX Nissan, unhook the positive cable on the battery first. Then take a picture of the headlight motor before taking the old one off. Remove the wires and screws holding the other motor in place, then place in the new motor, tighten the screws, and hook up the wires while looking at the picture. Connect the battery cable.
no it cant as, as long as the light isn't on
i would like to know as well
loosen the manual tensioners and the alt bracket.
Replace the window regulator
Had the same problem. Nissan covers this for the life of the vehicle, go to the dealer and let them replace the vehicle restraint system.
in the floor of the trunk or hatch
Yes it is, the Nissan 240SX was assembled in Japan and brought to America in 1989.
Nope, different body styles
The IAT sensor is located on the air box. Team Clockwork Performance
In the right fender right behind the battery
one screw holds the light on, take it off and spin the light lens holder to remove the bulb
Wat are the tps volt settings for a 1992 Nissan 240sx
nissan 240sx. it turns over but wont start
The problem is with the 240sx , a.k.a the s13 silvia , you will need something along the lines of a onevia kit , so basically you will need the bumber , lights m the headlight motor and wiring , go to your local body shop and ask what they can do , and also try to find a local wrecker with some parts from a 180sx or a 240sx onevia.
The fuel filter is located under the hood on the back firewall, passenger side.
On the 1989-1990 240sx with the KA24E single overhead cam engine the E.C.C.S. is located on the top left side of the engine behind the throttle body and on top of the intake manifold.
there are several in the fuse boxes near the air box (place where the air filter goes) and the fuse box near the battery
yes it will with the correct engine mounts, cross member and loom