It isn't easy. I have size 10 hands and was just able to do this work. On the passenger side, move the battery back as far as possible (taking it completely out isn't necessary but is very tempting), then find the socket hold-in assembly. This is a plastic cap, hand-tight, and must be screwed out, a slow process for me as I was only able to get fingers on it, not my entire hand. Be patient, rotate it little by little, and it will eventually turn free. Slide this back along the wiring. Next rotate the socket itself a quarter turn. This frees it from the housing and you are now able to remove it and replace the bulb. Place the socket back into the housing, tighten a quarter turn, then replace the hold-in assembly, again a very slow process. Driver side is the same process, but without the hinderance of the battery. 10 minutes should do the trick.
how do you replace the headlight switch on a 1993 cutlas ceria*
Look to the back of the headlight assembly. There will be a round sleeve where the wiring goes into the headlight. Twist this counterclockwise to turn the head light bulb assembly. Pull back on the assembly to remove it from the headlight casing. Replace with new headlight bulb.
Don't know of a headlight relay but the headlight circuit breaker is located in and part of the headlight switch.
How do I change the dimmer switch on my 1993 corvette?
call macgyver
Where is the fuse located that controls the inside dash lights on a 1993 Ford Explorer
open the hood unplug the bulb from the back of the light assembly and un do the metal clip, pull bulb out of replace with a new one and reinstall
specs on how to replace a heatercore on a 1993 ford explorer
Front wheel bearings on a 4 wheel drive Explorer are not serviceable, replace them.
Headlight Switch Is Located On left Side Of DashBoard Just under The Auto Headlight Dimmer....
The 1993 Ford Explorer fuse box is located in the engine compartment. The fuse box can be found on the drivers side behind the battery box.
The fuel tank will have to be removed from the Explorer. The pump is bolted in the top of the tank.