On the 1998 Buick Park Avenue, the headlight bulb can be replaced by raising the hood and removing the back panel of the headlight assembly. It is held on by two clips at the top. Then, remove the old bulb and replace with the new one, being careful not to touch the bulb itself. Touching the bulb will cause the bulb to overheat and burn out again right away because of the oil in the fingertips.
The headlights are bulbs that insert into the glass from under the hood. One is behind the battery. They turn 90 degrees and pull out. They can be tiresome to try to change
Remove the 2 thumb screws that hold the headlight in, then pull it towards the front of the car, give it a good tug they tend to stick, but be careful not to break it or rip the wires!
Remove the entire headlight assembly to gain access to the bulbs.
By removing the locks that hold the headlight assembly in place you can wiggle the headlight assembly out to gain access to the headlight bulbs for replacement.
Order replace done
Changing a headlight bulb in a 2007 Buick Lacrosse can be done easily. Just remove the cover piece and change the bulb.
To replace a headlight on a 2002 Honda Civic first prop the hood open. Locate the headlight housing inside the engine compartment. Find the bulbs and remove them. Install the new bulbs.
how to replace bulbs on a 2009 mitsubishi eclipse
The headlight assembly (aka the headlight bucket) is removable by releasing the lock tabs behind the assembly. Once the assembly is wiggled out in the open you can easily replace the bulbs.
How can I replace the headlamp on a 2000 Saturn SL1
detach the bulbs and remove the clips behind the headlight assembly
First open the hood and locate the 5mm studs in front of the headlight you wish to replace. Remove the studs and gently pull out the headlight assembly. Remove the headlight assembly by twisting the connectors counter-clockwise. Remove the old bulbs from the assembly and replace with the new bulbs. Reconnect the assembly by attaching the connectors and twisting clockwise. Reinsert the assembly and and attach with the 5mm studs. Close the hood.