1st take note which is the low beam and which is the high beam bulb. On top of the headlight assembly you will see 2 release tabs, pull up somewhat on each tab, they DO NOT pull all the way out. Then on on each of these then pull entire headlight assembly forward, you may have to wiggle to get free. Once you have the headlight assembly loose then turn the light connectors for both the side maker and turn signal light to remove them. Once the turn and marker lights are out of the way remove the dust caps on the back of the headlight bulb areas. Then turn the headlight bulb you want to replace to remove it from the housing. DO NOT TOUCH THE GLASS BULB AT ANY TIME, contaminants from your fingers will burn out the bulb. When you have the bulb out very carefully push up on the tab on the headlight connector while pulling the connector from the bulb assembly. Replacement is reverse of all of the above.
This person is right but if the car is REALLY old than you may not be able to replace it at all.
Where is the radiator cap located on a 2000 Oldsmobile Alero?
It is integrated into the alternator, if it is bad you will need to replace the alternator.
A 2000 Oldsmobile Alero V6 requires 6.8 quarts of Dexron III fluid.
i get about 21 mpg on a 2000 olds alero 3.4L v6
The cost to replace the head gasket of a 2000 Oldsmobile Alero costs between $20 to $190. This depends on where the part is bought, the brand of the park and any costs concerning labor or shipping.
no
sounds about right
It has a chain.
The relay panel on the 2000 Oldsmobile Alero is under the steering column and above the brake pedal. The relay pops out with a screwdriver.
I currently have an 2001 Alero and it has 200800 miles one it. I have not had to replace the engine or transmission. The only issue is the fuel injection. I pay that is all that goes wrong.
Try eBay, for about $10.
They are self bleeding.