0
How do you replace the hood release cable on a 93 Honda accord?
Wiki User
∙ 18y ago
www.cb7tuner.com Will answer all your problems
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
How do you replace a Honda Accord Lx 1995 clutch cable?
The 1995 Accord ghas a hydraulically operated clutch, notg a cable.
How do you replace the hood release cable on a 1996 Honda Accord 4-door sedan 4-cylinder?
If the cable is broken, tke it to the body shop as they have to open hoods on wrecks.
Where does the speedometer cable hook to on a Honda Accord?
The speedometer cable hooks up to the engine in a Honda Accord. This is how the vehicle is able to calculate speed.
Speedometer broke 94 Honda Accord?
possible cable Remove from transmission and check if in one piece - if not remove speedometer head and replace cable to transmission and head
How do you replace a starter for 1995 Honda Accord Lx?
follow the pos battery cable to find the starter. Remove the neg cable then the wires to the starter and the mounting bolts and work it out.
How do you disconnect the cable on the speedometer on 93 Honda accord?
I believe there is no cable to the center and speedometer
Where do they route the antenna cable in the 2003 2004 Honda Accord?
Is there a cable to the clutch of a 1996 Honda Accord?
No the clutch is hydraulic.
How do you replace the throttle cable to the gas pedal on a 1998 Honda Accord V6 3.0 Vtec engine?
The 1998 Honda Accord 3.0 liter engine does not have throttle cable. The automobile has throttle linkage. The linkage is connected at each end with a connecting bolt. Remove the connecting bolt to remove the linkage.
How do you release the fuel fill door when the lever doesn't work on a 2008 Honda accord?
You can pull on the cable for the fuel door. The cable is located in the trunk behind the side panel.
How do you replace choke cable in ATV Honda Foreman 450?
how do you replace a choke cable on a 2001 Honda 450 foreman
How do you replace the hood release cable on a 1999 Honda Civic?
The hood release cable snakes into the cabin of the car through the firewall. To replace the cable remove the old wire. Zip tie the new cable to the old one and pull it out. This will easily snake the new cable into place. Install the new cable on the release and lever.
