where is the ignition control module on a 1995 Pontiac Transport and how do i replace it
can you clean a egr valve on a 1995 pontiac firebird with a 3.,4 litre motor
By taking it to a GM certified auto technician.
its bolted to the motor
275 with the V8
Chevy 350 LT1
300 horse if it's a V8.
under the hood on the drivers side.
The fuel pump in any car is tricky, using its diagram can make the repairs easier. The diagram for a 1995 Pontiac Firebird fuel pump can be found in its maintenance manual.
take apart the thermostat housing and pop it out be sure and replace the gasket too. There should be two bolts holding it together.
check your erg valve.
Someone put it there.
it's inside the gas tank
It is behind the Harmonic balancer at the bottom pulley on your motor.
Pull out the old flasher (located under dash pannel above brake pedal, above the horn relay) and put in the new flasher.
You can find the 1995 Pontiac Firebird 3.4 liter engine IAT sensor on the back of your engine. The IAT sensor will be a few inches above the transmission.
3.4L V6 with 160 hp or 5.7L 275 hp
How do replace the ignition switch on 1995 Honda Civic EX with a manual tranny. I was wondering if it is pretty much the same as the 1995 Accord.
The 1995 Pontiac Firebird can be fitted with 18x8-inch wheels granted they are designed for this application. A tire size that will work on these wheels are 275/40/18.
Press the brakes all the way in kinda like a pumping fashion about three times. I have a 2000 firebird and that's what I have to do.
The 1995 Pontiac Firebird V-6 engine oil pump is located on the bottom of the engine. The oil pan will need to be removed in order to see the oil pump.
To replace the ignition fuse on a 1995 Mercury Villager, use a fuse puller to remove the appropriate fuse. Then replace broken fuse with one of the same amperage.
wiring diagram for a 1995 Pontiac fire bird 3.4 spark plug wiring diagram?
Inside the kick Panel behind the emergency brake pedal.