Pontiac Grand Am

How do you replace the ignition switch on a 1993 Pontiac Grand Am?

242526

Top Answer
User Avatar
Anonymous
2020-04-08 13:58:23
2020-04-08 13:58:23

Ignition?! WHO WOULD WANT TO BLOW UP THE CAR?! oh wait... I would....

12
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

User Avatar
Wiki User
2009-05-25 07:02:21
2009-05-25 07:02:21

It's really easy the switch is in the steering colume.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The switch is on the steering column about 18 inches from the floor under the dash. There are 2 screws that hold it on.

User Avatar

Grand? As in Grand Piano?? I can Play that for you ^^

User Avatar

PLEASE REMOVE IT I WORKED HARD FOR THE MONEY TO BUY THIS CAR T-T

User Avatar

The ignition switch in a 2004 Pontiac grand am can be installed by first Sliding out old lock cylinder and then Press the small release tab While turning the key to the ON Position.

User Avatar

Replacing a steering column ignition switch on a 2002 Pontiac Grand Prix is not considered a major repair. The task is considered easy but if done wrong could be dangerous. It is best to refer to vehicle manual for the car to ensure proper direction is given.

User Avatar

ignition what? coil, swicth,module, lock cylinder? gm Jim

User Avatar

You will need to remove the retaining ring at the top of your 1995 Dodge Grand Caravan ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.

User Avatar

how much to insall a ignition to a pontiac grand am se 1999?

User Avatar

The ignition switch is immediately behind and attached to the ignition lock cylinder. The ignition lock cylinder is where you place the key to start your vehicle. If you are haveing problems with your vehicle not starting and or turning the key, more than likely you need to replace the ignition lock cylinder. It is common for these to go bad in GM vehicles.

User Avatar

I don't know how to change the ignition switch but I have some advice. Don't screw with the ignition switch, buy the whole steering column. It will be cheaper and easier to change.

User Avatar

Need a little more info on what your trying to replace. Is it the switch in the dash? It's in the overhead console.

User Avatar

On my 2001 it is part of the Hazard switch. You have to replace the entire switch on a 2001.

User Avatar

How do you replace starter on2.3 cy 1991 pontiac grand am

User Avatar

how do I replace water pump 2000 Pontiac Grand AM SE1?

User Avatar

how to replace lifters on a 03 grand am

User Avatar

Pontiac Grand ams dont have an inertia switch, actually no GM cars that i know of have them.

User Avatar

first remove the dash trim around the switch. the trim should just pull off. its held in by push clips. next remove the screw that holds the switch, push in on switch a little then wiggle it out. remove the electrical connection from back of switch, then pull switch out. to install is reverse of removal.

User Avatar

It's located on the steering column 2 screws unplug the harnest

User Avatar

My turn signal switch died on my 92 Grand Prix. Rather than attempting the repair, I took it to a shop. The steering column had to be removed to get to the switch.

User Avatar

how do i replace a water hose in 1993 pontiac grand am

User Avatar

change ignition switch and/or tumbler

User Avatar

I got a friend whose key can't turn the ignition on her 2000 Pontiac Grand Am. She can't get the steering wheel to unlock either.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.