I have the same problem, going to have a locksmith make sure its the ignition switch and cylinder and just not a key problem or a tumbler problem.
The process of removing a 1998 Toyota Camry ignition switch requires taking apart the steering column and lower dash, as well as several of the under-dash relays. The ignition switch is connected to the key cylinder and cabin wire harness. A faulty ignition switch will prevent the car from starting.
Any of the following.... Bad battery, bad starter, bad ignition switch, bad neutral safety switch
try removing the negative lead on the battery for about 30 min that will reset your computers
I need to replace the ignition switch on a 1998 KIA Sportage . Can this be done with a universal ignition switch ? There are 6 sets of wires going into the KIA switch. The universal switches come with 3 or 4 posts.
Begin by removing the retaining ring at the top of your 1998 BMW ignition switch. The ignition switch will slide out. Remove the wiring harness.
One to repair an ignition switch on your Astro Van is buy a replacement steering column from a local salvage yard including the ignition key, and replace the whole steering column. RC Houston, TX
where is the starter located on the Audi a6 quattro
No, there is no kill switch except for the ignition switch.
How_do_you_remove_the_key_cylinder_in_a_98_Toyota_tacoma
We have a 1998 Bounder Motorhome (with ford engine) how do we replace the headlight switch?
the wire is Yellow coming out of the ignition switch going to the Neutural safety switch, then purple from the neutual safety switch to the starter
You will need to remove the retaining ring at the top of your 1998 Chevy Lumina ignition switch. Slide the ignition switch out. Remove the wiring harness.
Defective ignition switch.
I have the same problem, going to have a locksmith make sure its the ignition switch and cylinder and just not a key problem or a tumbler problem.
How do I replace ignition wires on my 98 Mazda 626 2.0L
key switch tumbler removal on 1998 astro