Want this question answered?
if your refering to the center carrier bearing on drive shaft , it is easy to do, get the new carrier bearing before you begin , two versions 6.5 inch and 7 inch. If your refering to the rear end carrier bearing, completely different deal. Which bearing ? axle or main pinion gear bearing ? let me know i have a complete rear end looking for a home out of a 2000 kia sportage.
Many carrier bearing assemblies must be pressed off and on the shaft. Sometimes it's best to take the entire driveshaft off the vehicle and have a driveline specialist shop replace all of the u-joints and the carrier bearing at the same time. For that matter, they don't usually charge much to remove and replace the driveshaft so it's often not worth the trouble to do it yourself.
Yes you can. The dealer will tell you that you need to replace the entire shaft, but a replacement carrier bearing (also called hanger bearing) is available at a supplier called Lindsay driveline. They can be reached at 1-866-944-6288.
to remove carrier bearing, u will need to removbe the drive shaft from the vehicle the carrier bearing is bolted to chassis with 2 bolts . these will need to be removed and the carrier and bearing will come out with the drive shaft one drive shaft is out you can then knock old bearing and carrier off of shaft with a hammer. the old carrier is no good so doesnt matter if you trash it once you get old one off, carefully known new one onto shaft until seated,being careful to note which is front of carrier bearing you can then reinstall cariier bearing and drive shaft to truck. NOTE: now is a good time to check and replace if needed the U-Joints on the drive shaft
Please answer the question Please answer the question
Don't really think so, the 306 has one short and one long drive shaft with an intermediate bearing carrier. You could try a dirct comparison side by side.
you can't replace it you have to buy whole new driveshaft assy. about 650.00 from dealer. or go to junkyard,or driveshaft shop to see if they can cut off yoke replace bearing and re-weld which is what i did. 2004 is the only year for this.
Which differential bearings? Pinion bearing? Carrier bearings? End axle bearings?
How much to replace blower and capacitor on carrier 48gs030?
You can get one from Lindsay Driveline. 1-866-944-6288.
rear ryhits bearing
To replace a throw out bearing in any car or truck you must remove the gearbox, then remove the clutch, then pull the bearing out of the flywheel and replace it. Assemble in reverse order.