Want this question answered?
I AM GETTING A OBD CODE ERROR FOR MY 2000 NISSAN QUEST , PO141 AND PO325 ??? HOW DO I FIX IT..
how many gaskets and which ones are needed when you replace the knock sensor on a Nissan frontier w/a 3.3l v6 engine?
The knock sensor for most Nissan V6 engines is located directly under the intake manifold. So to replace it, you have to remove the intake manifold. Good Luck.
With mucho effort, that's how. The sensor is behind the intake manifold, throttle body ect, all of which must be removed. Labor alone will be 5-6 hundred , knock sensor another 150 or so. Good luck.
If just the knock sensor need to be replaced. I would say no more than $150.00
The knock sensor on a 1998 Nissan Quest is also located under intake manifold and yes alot of work but can be done in a day. 120 dollar part and 500 labor at garage but for u at home mechanics just a simple side project.
Never mind, I got my answer.
It is behind the intake manifold on the left side of the engine. It will take almost 6 hours to replace this cheesy part ($120) and cost about $500 in labor alone.
the Knock sensor is located behind the Harmonic balancer pulley. on the bottom sidethe sensor is $95.00 remove the lock down screw unplug and replace
the knock sensor is located under the intake manifold, with a flash light you can see it however you have to remove the intake manifold to replace the knock sensor , also you will need to replace the intake gasket set as well!
You don't. You buy a new car.
The knock sensor sub-harness connector is located on the passenger side of the engine compartment next to the intake manifold. Must be checked by observing voltage fluctuations with a voltmeter.