Wiki User
Answered 2007-10-31 19:58:59
take panel off under ignition switch.turn switch to run position.look up under switch you will see a little pin .push pin in and pull cylinder out.i just did this and it works.remove battery ground first
Your Answer
Still have questions?
Related Questions
How do you replace the slave cylinder in a 1988 ford F150 6 cylinder fwd?
you just replace it
What does a car quest oil filter 85515 fit?
1992 ford f150 straight six cylinder
How do you change the battery on a 2001 Ford F150?
How do you remove and replace the battery on a 2001 Ford F150?
Does a 1992 ford f150 have a torsion bar?
NO
How do you replace slave cylinder on 1989 ford f150 4x4?
You Must remove the trans to access the slave... on the 5 speed for sure.
Where is the cylinder head temperature sensor on a 2001 Ford Mustang?
where is the CHT sensor on a 2000 ford F150 where is the CHT sensor on a 2000 ford F150
Where is cylinder number 1 on a ford F150 4.9 6-cylinder?
cylinder # 1 is the front cylinder on your straight 6
How do you replace evaporator on a 1992 Ford Explorer?
How do you replace evaporator on a 1992 ford explorer?"
How do you fix a ford F150 misfiring in cylinder 5?
start with wires
Where can one purchase a master cylinder for a Ford F-150?
A Ford dealership would be the best place to find a master cylinder for a Ford F150. Parts Geek, Parts Train, and eBay also have master cylinders for a Ford F150 for sale.
1993 Ford f150?
how to replace an oil pan that goes to a ford f150 1993? how much does the pan cost,and can you show a picture of it?
Where do you put brake fluid on a 1985 ford -f150?
you put the brake fluid inside the master cylinder
1992 f150 ford 300 6 cylinder at 35 mph it has a miss in motor?
i have a whole new tune up in motor 37.000 miles on motor
How do you replace tail gate latch for a 2001 ford 150?
How do you replace the tail gate latch on a Ford f150
Where is cylinder 8 in a 2002 F150 4.6?
The Ford F150 was produced from the years 1948 to present in the United States. The cylinder 8 in a 2002 F150 4.6 is located against the driver side firewall.
How do you replace the window regulator on a 1993 Ford F150?
What question
What steps do you take to remove and replace the master clutch cylinder of a 1992 Ford Ranger?
If you need to replace the slave cylinder it is located in the bell housing and the trans has to be removed. The clutch master cylinder is located on the firewall on the drivers side
Where is cylinder 1 on 1989 ford f150 5.8L?
front passenger site
What is Error code P0301 on a ford f150 2006?
misfire # 1 cylinder
Does a 1984 ford F150 6 cylinder have rotors or drums on the front?
Rotors
How do you replace a Ford F-150 rear axle seal?
how do you replace a Ford F150 rear axle seal
Where is the spout connector on 1992 ford f-150?
where is the spout control on a 1992 ford f150 300 6 cyl
How do you replace the ignition cylinder lock on a 1991 Ford F-150?
do you want to know how to replace the ignition switch, which is not visible, and is the electrical part lower down on the column, or do you want to know how to replace the ignition lock cylinder, where you put the key in? *another thing to remember is that there was a recall on that part of an 89 f150. you can get it fixed for free at any ford dealership.
How do you replace the alternator on a 2001 Ford F-150?
how to install alternator2001ford f150
What is the approximate cost to replace a cylinder in a 2003 Ford Ranger?
what sort of cylinder you want to replace?
