Radiators
Honda Accord
Honda Accord EX

How do you replace the lower radiator hose in a 91 Honda Accord?

293031

Top Answer
User Avatar
Wiki User
2008-11-03 21:23:14
2008-11-03 21:23:14

how do you put on the lower radiator hose on a 91 honda prelude?

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

follow the lower radiator hose from the radiator to the water pump

User Avatar

follow lower hose to rear of engine. rember to bleed. bleeder located on the upper radiator hose housing.

User Avatar

The radiator drain plug on a 1988 Honda Accord LX is located on the lower right side of the radiator. If facing the vehicle from the front, it would be on the driver's side of the radiator. To drain easily, loosen the radiator cap after opening the drain plug.

User Avatar

The thermostat in a 1992 Honda Accord is found in the thermostat housing. The thermostat housing can be found by following the lower radiator hose.

User Avatar

BELIVE IT OR NOT ---- some are located on the lower radiator hose mount.(the place where the lower hose connects 2 the engine)

User Avatar

The water pump is driven by the cam belt. The lower radiator hose connects to the water pump.

User Avatar

On the top end of the LOWER radiator hose. Under the air intake hose.

User Avatar

If you follow the lower radiator hose to the engine block, it will lead you towards the thermostat housing (inside there is the thermostat),

User Avatar

The valve is on the passenger side of the car follow the lower radiator hose back to the thermostat housing and it be top

User Avatar

Remove the oil pan drain plug to drain the oil. Remove the lower radiator hose to drain the coolant.

User Avatar

It is on the lower right of the radiator and sometimes it is easier to take the lower radiator hose off.

User Avatar

AnswerShould be in a removable housing at the engine end of the upper radiator hose The thermostat is in a housing at the engine end of the LOWER radiator hose. Remove the air intake tube to access it.

User Avatar

The 2001 Honda Accord lower ball joint torque specification is 90 pounds. The lower ball joint should be torqued in 45 pound intervals.

User Avatar

Follow the lower radiator hose to where it connects to the engine, in the rear near the firewall. Remove the air intake tube to access it.

User Avatar

i have 98 Honda accord, has three fuse boxes. look on passenger side of dash.( lower) Also, one on the drivers side. (Lower) . These should be pull open panels

User Avatar

Should be at the bottom or rear of the radiator or remove lower radiator hose

User Avatar

It is at the end of the lower radiator hose on the motor. You will have to empty the radiator and remove the housing to replace it.

User Avatar

The oil drain plug is located on the bottom of the engine on the oil pan. Remove with 17mm wrench and tighten to 10 Lb/Ft torque and no more. The radiator drain plug is located on the bottom of the radiator. If you can't find it simply remove the lower radiator hose to drain the radiator.

User Avatar

(3) One on the left side, One on the right side and One on the cross member comming off the lower Radiator Support.

User Avatar

Well, I assume that a Honda accord has 4 wheels so i'd say both. But i think a standard accord in the lower price range comes with front wheel drive.

User Avatar

The upper radiator hose is attached to the thermostat housing.

User Avatar

THERE IS NO HOSE, THE WATER PUMP IS FED BY A METAL COOLANT PIPE LOCATED UNDERNEATH THE INTAKE MANIFOLD. THE LOWER RADIATOR HOSE CONNECTS TO THE PIPE.

User Avatar

The 2000 Accord does NOT have the LATCH anchors. It does have 3 tethers.

User Avatar

The transmission. The vehicle speed sensor (VSS) is located on top of the transmission, in back, just under the thermostat housing at the rear end of the lower radiator hose.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.