In order to replace the master cylinder with ABS attached to the master cylinder on a 1995 Grand Am you will need to complete the following steps:
Once all of these steps have been completed you can be sure that your master cylinder has been properly replaced and is ready for use.
my husband is trying to replace the master cylinder on a 1994 grand am. he was wondering on how to align the gears for the abs.
about 1500 dollars
Need to know if it's a 4 cylinder or a 6 cylinder.
Most ABS actuator pumps are located either on the master cylinder or the firewall right below the master cylinder. Either case, follow the hydraulic line from the master cylinder until you find the actuator.
The brake master cylinder has nothing to do with the way the car runs. It certainly wouldn't cause it to stall.....Maybe the brake booster?
Replace it.
Give more detail what year of grand prix do you have what model grand prix do you have what is the engine size does it have abs
Before installing the master cylinder you do need to bench bleed it. Some brake master cylinders come with a bleeding kit to make bench bleeding the master cylinder easier, purchase a bench bleeding kit if yours did not come with one. The master cylinder bench bleeding kit consists of adapter fittings that screw into the master cylinder and tubes that attach to the fittings of the master cylinder. Place the master cylinder in a vise and attach the brake master cylinder bleeding kit routing the tubes into the master cylinder reservoir. While keeping the tubes submerged in brake fluid of ther reservoir, push the master cylinder piston in repeatedly using a screwdriver. You will see air traveling through the tubes into the reservoir by keeping the tubes in the fluid you are preventing air from re-entering the master cylinder when the piston returns. When there is no more air traveling through the tubes the master cylinder is ready to be installed. DenLorsTools.com has a related tech article that goes into more detail, the link is in the left column. See the Related Links for "DenLors - Master Cylinder Bench Bleeding" to the bottom for the answer.
The Jeep Grand Cherokee didn't exist until 1993.
The ignition switch is immediately behind and attached to the ignition lock cylinder. The ignition lock cylinder is where you place the key to start your vehicle. If you are haveing problems with your vehicle not starting and or turning the key, more than likely you need to replace the ignition lock cylinder. It is common for these to go bad in GM vehicles.
It is just below the Master Cylinder and the Power Booster assembly.
replace the coil bar and you are set