the 1989 Honda accord lxi has a brake lamp light on the dashboard, if the brake lamp light is on, this means you have a brake/tail light out or disconnected
For more complete instructions, see: http://www.faqfarm.com/Q/How do you change a front corner lamp on a 1990 Honda Accord LX
just had oil change on saturday. no problems. now brake lamp light on 2000 honda accord ex
On a 1994 Honda Accord, the brake lamp comes on when a tail light is no longer working. The burned-out bulb needs to be replaced. The brake lamp will not come on after the bulb is replaced.
The clock face plate will come off with a small screw deiver. The bulb is right there. It costs about $20.00.
it is an indicator. You need to check your brake fluid or your bulb.
My 1992 Honda Accord Brake Lamp came on several times after I had the Master Cylinder replaced. Turns out the fluid had gotten low. Once I refilled the fluid level, the light stopped coming on.
fuesed breaklamp replace bulb.
exhaust recirculation system
Pop your hood and there should be one screw holding it in place then just pull the corner assembly straight forward.
if it isn't a fuse or lamp problem, check the brake lamp switch on the brake pedal, if you unplug the switch, and jumper the connection, and you have brake lamps, replace the switch...
For Honda Accord 95: Use small blade screwdriver to gently pry front edge of dome light lens cover off of its retainer. Use fingers or screwdriver to remove lamp bulb. Replace lamp bulb with the same type bulb. Be certain that the size of the new lamp barrel is the same as the old lamp. Reseat the dome light lens cover into its retainer. Note the orientation of 4 tangs on the lens cover that must seat into the lens retainer. Check to verify proper operation of the dome light and its switch.
Changing the lamps is pretty straight forward. There is a cover over the lamp assembly, remove it. Then, turn the tail lamp (with the connector) counter clockwise about 1/4 turn. Pull the assembly forward, then replace the lamp. Installation is the reverse of removal. Hope this helps.
It means the light bulb(s) on the rear break lights have gone out and your rear break lights do not come on when you depress the brake pedal. Just replace both rear break lights and the sensor will go off. This happened on my 2002 Honda Accord.
Low brake fluid level or Parking brake not released completely
It means one of your rear brake lights are out. Not the tailights but the brake light(s).
It's telling you the brakes need attention. Have a trusted garage check it out now!
Remove the negative battery terminal (-) for about 15 minutes and most codes will reset.
If the brakes are still operating normally, check the tail light bulbs.
Try contacting your local used auto parts dealer.
Blown lamp or fuse. Poor connection. Switch not working. Break in circuit
It means your alternator is going.. atleast that's what it meant when it happened on my 2000 accord ex.
Normally it means the brake master cylinder is low of fluid. But it can indicate another problem.
Check brake fluid level in master cylinder Make sure parking brake is fully released
You do not specify what this red lamp looks like but redmeans STOP, so it is either the oil pressure light or coolant temperature.