Windows and Mirrors
Mazda MPV
DIY Projects

How do you replace the passenger side mirror on a 2000 Mazda MPV?


Top Answer
User Avatar
Wiki User
2010-11-13 21:00:41
2010-11-13 21:00:41

This is for a 2002 model, but I would assume they are pretty much the same.

1. Pop off the plastic screw cover behind the inside door handle and remove screw. 2. Pop off the plastic screw cover in the recessed area where you grab the door to close it and remove screw. 3. Remove two (or possibly more) plastic screws around outside edge of door panel. 4. Pop out the plastic light cover near the bottom of the door.

The door panel should now come off. It will probably be connected with the wire for the mirror if you have power mirrors. To replace, reverse the steps above. Sorry if I left something out. I did mine by trial and error and ended up breaking the plastic light cover because I forgot about it.

Updated on 11-13-2010 for a 2005 Mazda MPV LX model:

It was the same, with where the screws were located. (Thank you!) Our model had 2 plastic screws on the edge of the door, one on top and one on bottom.

The mirror was held on by 3 nuts; make sure you have an extension bar for your socket wrench, or scrape your knuckles.

Here's the tricky part:

The cord for the new mirror is about an inch or so SHORTER than the mirror part that you'll be replacing. I ended up popping off the riveted clamp that held the electrical connector, and rerouting it so they would be able to reach each other.

There's a black sticky 'goo' glue keeping the plastic stuck to the door. Just make sure you seal that back properly & tightly.


Related Questions

The disconnect on the passenger side vanity mirror caused the dome lights - radio - auto locks to be come inoperable - has anyone had the experience and what is the cure?

How to replace passenger side view mirror on 2000 GMC Yukon?

how to remove a passenger side mirror on a 2000 toyota 4 runner

if you take off the door panel there will be three studs that connect the mirror to the door

Sure you can. Just do a google search for passenget side mirror - Ford explorer. It will run about $50.

to replace the passenger side mirrior you remove passenger door panel then the bolts that hold it on will be right there just take them off and put the new one back on

there is a plastic insert on the inside part of the door remove it and there are two bolts holding it on.

Pop the trim on the leading edge of the window. There will be I believe three nuts to take loose. If the mirror has electric adjustment, it will simply unplug.

How do you replace the bulb in the mirror of a 2000 E320 Mercedes

There is no fan belt on a Mazda Miata.

How to replace passenger side head light bulbs in a 2000 Honda Accord?

Mercedes E280 2000 model passenger side wing mirror removal in order to repair automatic reverse mirror adjuster.

o man well here is the best way........JUST LEAVE IT ALONE WHO CARES

The firing order for the spark plugs in a 2000 Mazda B3000 start on the passenger side. The order is as follows - passenger side front, passenger side center, passenger side rear, driver side front, driver side center, driver side rear.

under the triangle on the door there are 3 screws and a wire-if the harness connects at the mirror you can just unhook it there-if it goes into the door panel you need to remove the panel to disconnect the harness

The 2000 Mazda Protégé map sensor is located next to the system computer. The map sensor and the system computer can be found behind the kick plate on the passenger side of the passenger compartment.

You need to remove the inside door panel, then remove the bolts that secure the mirror. It is very simple procedure.

The 2000 Mazda Miata O2 sensor bank 1 is located on the firewall in the engine compartment. The sensor can be found on the passenger side of the firewall.

The auto dimming rearview mirror contains chemicals that have either leaked out or deteriorated over time. You will have to replace the mirror.

According the manual book ,mazda proteges 2000 has timing belt and should be replace at 105 K miles .Hope would help .

remove the complete dashboard and then replace it

Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.