There should be 2 bolts holding the old one on. Remove them and replace it with a new on from a parts store.
Just follow the positive battery cable, not far, and there it is.Under $ 20. to replace.
Look for a loose or corroded positive battery cable at the battery post - or a loose/corroded battery terminal on the positive cable.
If You Are Running A Cable From The Battery ( Bypassing The Solenoid ) You Starter Runs Then It Would Most Likely Be You Have Lost Connection On The Solenoid From The Battery Side. ie You Probable Have More Than One Cable On The Battery Incomming Side Of Solenoid Clean All Cables At Battery And Where They Connect To Engine Block ( Negative ) And All Positive Connections Also Check Battery Cables Sometimes They Will Accumilate Lots Of Corrosion Under The Plastic Cable Covers On The Battery End Of Cable, Replace Cable If This Is So. If This Gets It Going I Suggest You Replace Solenoid Also. BEST I CAN DO
The battery post positive terminal is where you connect the positive cable. Connect the negative cable to anyplace on the engine or chassis. Connect positive first and remove it last.
The vehicle battery's main purpose is to supply power for the starting system and to power some accessories when the engine is not running. The proper procedure for changing or installing a battery... remove the battery cable first from the negative battery terminal, then from the positive. Install opposite, attach the positive cable lead, then the negative.
From battery to starter solenoid
buy the proper battery and the cable will fit, or replace the cable with on that will
To change the positive battery cable on a 1988 Jeep Cherokee trace the end of the cable to the starter. Unplug the battery then remove the cable from the starter. Measure the old positive cable with the new and be sure to replace the unit at the right size.
with copper wire
Remove - battery cable Remove + battery cable from battery and starter solenoid Route new cable following original routing Connect to starter solenoid Connect to + battery terminal Connect - battery cable
Disconnect the cable from the LeSabre battery. Follow the route of the cable and disconnect the other end. Pull the cable out, then fit the new cable in the same direction. Connect the non battery end, then connect to the battery.
follow the positive battery cable to the starter.
Remove old one from battery and starter solenoid and replace with new following the same rounting
disconnect negative side first.... then disconnnect all connections to the pos cable labelling as you go... replace with new cable... reconnect to battery.
Open your car hood. Remove the black (-) negative cable from the old battery . remove the positive(+) cable from old battery . remove the two small nuts which hold the battery in place . remove old battery . replace with new battery . reverse directions for installion .
Disconnect the negative cable FIRST!..then disconnect the positive and remove.
You have to remove the starter and run a new wire