Dodge Intrepid
Toyota Camry
Ford E-150 Van
Ford Ranger XLT

How do you replace the rear drivers side seat belt on your 98 Dodge Intrepid?

456

Top Answer
User Avatar
Wiki User
2010-12-02 01:36:16
2010-12-02 01:36:16

no. check fuses and relays.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The 3.5 litre V6 engine in a 2004 Dodge Intrepid has a timing BELT

User Avatar

Flush and replace the engine coolant. Replace the engine timing belt or chain. Replace the spark plugs & wires.

User Avatar

3.3L has a chain. 3.5L has a belt.

User Avatar

2.7L has a chain 3.2 and 3.5L have a belt. The chain does not have a service interval. Replace the belt around 100,000 miles

User Avatar

In a 2004 Dodge Intrepid : The 2.7 litre V6 engine has a timing CHAIN ( also , the 3.5 litre V6 engine has a timing BELT )

User Avatar

All you have to do is loosen the idler pulley and the belt is a snap after you do that. just tightin bolt after the belt is on. good to go

User Avatar

3.3L, it is external and driven by the serpentine belt. 3.5L it is internal and driven by the timing belt.

User Avatar

The 3.3 it runs off of the serpentine belt. The 3.5 it runs off of the timing belt.

User Avatar

3.2L, in the front of the motor behind the front engine covers. 2.7L, no belt, is a timing chain.

User Avatar

3.5L, yes. It is driven by the timing belt.3.3L, no. It is external.3.5L, yes. It is driven by the timing belt.3.3L, no. It is external.

User Avatar

The Ram does not have a timing belt.

User Avatar

checck beside the fan on the inside of the motor compartment. its hard to find sometimes. if you can't ceck your car book for the answer.

User Avatar

i had the same problem with my 02 intrepid it was the idler pulley to the ac belt $19 to fix it.

User Avatar

It must have a TIMING CHAIN because Gates ( they make timing belts etc. ) does not list a timing belt for a 1997 Dodge Intrepid 3.3 liter V6 engine

User Avatar

take off the radiator and then the harmonic balancer and then take off the two cam shaft/ timing chain covers on the front of the engine and then you replace it with a new one and make sure the belt is positioned on the same teeth as the old one and do not turn the cams!@

User Avatar

inside the front of the engine, driven by the timing belt

User Avatar

the water pump is driven by the timing belt.

User Avatar

It typically costs between $100 and $150 to replace the serpentine belt on a Dodge Dakota. The belt costs around $30 with the rest being labor.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.