Headlights Tail and Brake Lights
Chevy S-10
GMC Yukon
Turn Signals and Hazard Lights

How do you replace the rear turn signal on a 2002 Chevy S-10 pick up?

101112

Top Answer
User Avatar
Wiki User
2006-03-29 22:57:19
2006-03-29 22:57:19

If ytou lower the tail gate and remove the screws on the inside it will slide out and then you can get the bulb pulled out and replaced.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how do you replace the rear wheel bearing on a Chevy pick up

User Avatar

How do you replace the front drivers seat on a 1996 Chevy S10 pick up truck

User Avatar

You have a dead short somewhere, it could be in one of the the bulb sockets, the wiring or the signal switch.

User Avatar

Check the auto parts websites for a 2002 Chevy pickup. There should be a picture of the individual parts.

User Avatar

what is the oil capacity for a 2002 Chevy s-10 pick up four cylinder engine

User Avatar

If there is a recall your Chevy dealer can help you. You can also look at the link I will post.

User Avatar

how to replace the rear seals on a 1991 Chevy S-10 pick-up truck

User Avatar

I have a 2002 Chevy SilerRado 1500 Pick up Truck, 2 wheel drive. My broblem is with the heater not coming on. I checked the fuse Box on the drivers side of the dash board label HTR/COOLING. The fuse was ok. I would like to know how to locate the Heater Core and replace it if possible. I haven't checked the thermostat. thanks in advance

User Avatar

The pick up box on a 2001 Chevy pick up is not the same as the pick up box on a 2007 Chevy pick up. These are different year models.

User Avatar

you have 2 they are in exhaust head pipes are stainless steel

User Avatar

There are several sending units in that vehicle, need to know which one.

User Avatar

if its not in your fuse box it will be under the dash drive safe

User Avatar

get a sledge hammer and beat it to little pieces and pick them up and replace them with ones that r not broke. I need the answer myself.

User Avatar

Take off the old one, put the new one on.

User Avatar

Remove door panel, remove 4 screws, remove speaker, put new speaker in, replace screws, replace door panel. Done.

User Avatar

will a 1995 Chevy 350 lt1 motor work in a 1990 Chevy pick up

User Avatar

removing and replacing 2005 Chevrolet Silverado extended cab head liner

User Avatar

You will need to remove the fuel tank to gain access to the fuel pump.

User Avatar

Chevy did not make a pick you p truck in 1941.

User Avatar

*what can i do to get more room in my 81 Chevy pick up

User Avatar

Yes you do. You have to take the distributor shaft out of the distributor to Remove the pick-up coil / stator.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.