How do you replace the rear windshield wiper on a 2004 Toyota Sienna?

Answer 1

EASY TO DO YOURSELF

1. Pop off end cap at BASE of wiper arm.

2. Remove nut with 10mm wrench or ratchet.

3. Remove whole arm. Might have to rotate counter clockwise to

work it off.

4. Fold wiper blade assembly all the way back and it just slides out at angle.

5. Set new blade assembly in and reassemble arm and cap

They should have these instructions in the dealer part bag because I could

have broken the wiper arm. Luckily I googled this question after I became frustrated on how to remove the old one. there is an insert available if all that is wrong is the rubber part. just slide it out,put the steel ribs on the new one, and reinstall it. if the blade is broken i think you have to have the whole arm which is a matter of pulling the cover off the pivot point, removing the 10mm nut, bang the arm with your hand to loosen it, and replacing the arm