0
How do you replace the remote door lock controller on a suburban?
Wiki User
∙ 15y ago
first you remove the front wheel guard (left or right side) .After you remove the door side wiring connector from body side main connector where located at the sill side inner pannel. after you will findout the door lock actuator terminal (at door side wiring connector)and act the actuator by a 12v battery.it is the way to release the latch lock of the door after you will open the door.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How can I replace the battery in my Dominator garage door opener remote control?
IF MY GARAGE DOOR REMOTE IS NOT WORKING AS WELL AS IT ONCE DID, IS THERE A BATTERY IN IT THAT NEEDS TO BE REPLACE??
How do you replace the drivers door handle on a 2001 suburban?
Need to know if it is an inside or outside door handle.
How do you replace a drivers door on a 1994 Chevrolet suburban?
take it to a auto shop
How do you unjam a lock on an open rear door of a 1994 Suburban 2500?
replace the door or buy a new car.
How do you unlock a 2001 Chevy Suburban?
Put the appropriate key in the door, and turn. Or use the remote if you have keyless entry.
How do i fix a 1994 gmc suburban door latch that's stuck and the door won't shut?
Remove door panel and replace latch mechanism
How do you replace a rear speaker in a 1999 Chevy Suburban?
rear door-remove the door panel. back speaker carefully pry off grille cover and replace speaker
Where can someone purchase a Liftmaster remote?
One may purchase a Liftmaster brand remote for a garage door at Sears department stores. They sell complete garage door opener system and replace parts such as the remote for the Liftmaster brand.
How do you fix a sagging door on a 1996 suburban?
You can fix a sagging door on a 1996 Suburban by replacing the door pins and the bushings.
Where is the Door Lock Module located on a 99 Suburban K1500 and how do you replace it?
In the compartment where the jack is. It is in a black box by the pillar. Open lid and remove circuit board and replace it.
Where is the Blend Door Actuator Motor on a 1994 Chevrolet Suburban and how do I access and replace it?
The blend door actuator on the '94 Suburban is located just above and to the right of the accelerator pedal. There are 2 - 7mm screws that hold it in place and 1 wire harness connection.
How do you set Garage Door Opener On 2005 Lexus ES330?
steps to set the remote control buttons on ES330: 1) close your garage door, set the opener in lock status, 2) push the button of a existed remote control for your garage opener, at the same time push a selected button of the remote controller on your ES330, keep pushing the both buttons for over 15 seconds until there is quick flash happened in your ES330 car's remote controller, 3) push the leaning button in your garage opener once, then a leaning light will flash on the opener, 4) then immediatelly push the selected button of the remote controller on your ES330 once, then push the button again, if the door did not open at this time, you should push the button again. 5) now the you finished the setting on the remote button in your ES330.
