0
How do you replace the starter in a 89 dodge caravan with a 2.2 eng.?
Wiki User
∙ 14y ago
You could take it to a dealership or auto shop and have them swap it out.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is the engine oil capacity for a 2002 dodge caravan 2.4 l eng?
4.5 quarts
What is the diagnostic code 355 on a 1992 Dodge Caravan 3 liter Eng?
means its time to buy a Chevy
Dodge caravan 2001 eng code p0304?
Trouble code P0304 means:Cylinder 4 misfire detected
Can you replace the main bearings on a dodge ram 1500 w the eng in the truck?
No you can not
How do you install a chevy 350 in a dodge d100?
BIG job,costly. Replace with mopar eng. 318-360.
Pcv valve location on 99 dodge caravan 3.3 eng?
between firewall and engine, between a rubber hose that leads to the valve cover and a short 90 degree hose to a vacuum nipple.
What is the code po171 for dodge caravan 1997 2.4 eng?
The code for a P0171 means the system is to lean.Check for a vacume leak first.You could also have low fuel pressure or a bad O2 sensor.
Where is crankshaft sener on 2002 gmc 5.3 l eng?
It is behind the starter, You will need to remove the starter to get to it.
How do you remove a starter from 1994 dodge spirit with a v6 eng?
A Starter is simple to remove... if you have the 2.5L engine, its just 2 bolts on the trans behind the engine and 1 below the starter... alot says the bolt that's below that you have to remove it from underneith, I never do, I always take all bolts out from the top.
How do you replace the starter on a 1993 Chevrolet Lumina 3.1 eng.?
Buy yourself a Hayne's or Chilton's repair manual at any auto parts store. Here you will find the info you are looking for.
How do you remove the dash of a 2003 Dodge Grand Caravan to get access to the Check Engine light bulb?
remove it and it wont start if that light burns out oris removed the eng wont start it shuts down the computer on most new modles
Where is the crankshaft position sensor located on a 1999 dodge caravan with 3.3 liter engine?
it is the sensor that sticks in the bell housing between the eng and trans held in by a 10mm bolt top back side of the trans remove the snorkle and air box to see it
